TOOTHPIC RF Solutions, TOOTHPIC Datasheet - Page 12

• Manufacturer Part Number: TOOTHPIC
• Description: MODULE, BLUETOOTH, DATA ACQUISITION
• Manufacturer: RF Solutions

Specifications of TOOTHPIC

• Svhc: No SVHC (15-Dec-2010)

Programming ToothPIC
Wireless Field Programming
Using Service Packs
To use a Service Pack to load a Firmware Solution or product upgrade, you will need a Bluetooth-enabled
Windows computer or Pocket PC. Start the program and a dialog box will appear similar to the one shown
below. Programming is as follows:
Upgrading ToothPIC Services Using Service Packs
From time to time ToothPIC Services may be upgraded. If developing using MPLAB, these upgrades will take
the form of a new ToothPIC303.lib file. If developing using Firmware Solutions, the upgrade will take the
form of a service pack as described above, with the following differences:
Page 12
1. Power up ToothPIC with the pushbutton held down.
2. Using the Bluetooth software on your computer, search for ToothPIC and make a serial connection to
3. Press the update button to start programming. The red and green LEDs will flash alternately during
simultaneously to indicate that it is ready to be programmed. Press the button again if you want to
return to normal operation.
it. The Bluetooth software will tell you which COM port it is using and you should enter the COM port
number in the box provided.
programming. The progress bar will flash three times when programming is complete. ToothPIC will
then reset itself and start running the new Firmware Solution.
• You will get a message during programming that ToothPIC has reset and is waiting for you to
• If for some reason you do not complete the upgrade, restart the ToothPIC Services upgrade from
• Your firmware solution will be overwritten so you must reload the Firmware Solution you wish to
9-Apr-06
reconnect. Reconnect as specified in step 2 above and press OK. It will take longer than usual for
the connection to complete.
the beginning.
use.
Toothpick 3.0.00007
DS380-8
© FlexiPanel Ltd
Patents apply and/or pending
The red and green LEDs will flash
and enter the COM port used
3. Press Update and monitor
1. Power-up with the button
2. Connect using Bluetooth
down so the LEDs flash
progress on the meter
www.FlexiPanel.com