ER900TS EASY RADIO, ER900TS Datasheet - Page 18

• Manufacturer Part Number: ER900TS
• Description: MODULE, TX, FM, 860-920MHZ
• Manufacturer: EASY RADIO

Specifications of ER900TS

• External Depth: 3.8mm
• External Length / Height: 12.5mm
• External Width: 32mm
• Frequency: 868MHz
• Operating Temperature Max: 65°C
• Operating Temperature Min: -20°C
• Output Power: 10mW
• Range: 150m

i)
despatched on or after 5
To successfully send a command do the following:
The commands should be sent exactly as shown (case sensitive) with no spaces between characters. The
ACK command is sent as three ASCII characters, ACK in sequence. ‘A’’C’’K’ .
Note that the TS (transmitter) devices send data ‘over air’ as they are not equipped with a serial data out or
handshake pins. This takes approximately 20mS and time should be taken in to account before sending the
‘ACK’ sequence
“FAST ACK”
In this mode the procedure to update settings is made much faster. In response to an ER_CMD#x string the
TRS/RS module will reply with a single HEX 6 (0x06) which is the ASCII ACK value. The host will then issue
the same single byte 0x06 in replacement of the Txt version of “ACK”.
LPRS Data Sheet
ERx00-02 Series V2.3
TEST MODES
ER_CMD#T0
ER_CMD#T1
ER_CMD#T2
ER_CMD#T3
ER_CMD#T4
1. Send Command from host:
2. In the case of a TRS/RS:
3. Send the ASCII string from the host:
Recommended setting for EN300-220 compliance This setting is effective on ALL ER900TRS/RS/TS
In the case of a TS:
o
o
Datasheet Revision 2.3 Sept 2005
Wait for echo of command from module.
Wait 20mS
th
Upper FSK Carrier
Modulated Carrier
Lower FSK Carrier
Get Firmware
Revision
RAW Data Test
September 2005.
ER400TS Transmitter, ER400RS Receiver & ER400TRS Transceiver
ER900TS Transmitter, ER900RS Receiver & ER900TRS Transceiver
e.g.
Easy-Radio ‘02’ (2
ER_CMD#U5
ACK
Copyright LPRS 2005.
nd
e.g. ER_CMD#U5
Generation Modules)
(Set UART BAUD to 38400)
Test Mode 0
Test Mode 1
Test Mode 2
Returns Firmware
String: eg
ER400TRS-02V2.01.5
Out of CTS pin
Page 18 of 30