E53-CK03 Omron, E53-CK03 Datasheet - Page 7

• Manufacturer Part Number: E53-CK03
• Description: RS-485 OPTION E5CK
• Manufacturer: Omron
• Type: Temperature Controllerr

Specifications of E53-CK03

• Rohs Compliant: YES
• Accessory Type: RS-485 Communications Unit
• Analog / Digital: Digital
• Control Method: ON/OFF and PID Control
• Voltage Rating: 100 V to 240 V
• Mounting: Panel
• Counting Method: Up or Down (Selectable)
• Size: 100 mm L x 58 mm W x 48 mm H
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: E5CK
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: E53CK03

J Mounting the Controller
Note: On a standard model, set up the output boards for control outputs 1 and 2 before mounting the controller.
1. Insert the Controller into the panel’s mounting hole at the position shown in the figure below.
2. Push the adapter along the Controller body from the terminals up to the panel, and fasten temporarily.
3. Tighten the two fixing screws on the adapter. When tightening screws, tighten the two screws alternately keeping the torque to
Terminal Cover
The E5CK-AA1-500 Controller is provided with a terminal cover E53-COV07. Fasten the terminal cover as follows by using the snap pin.
Input Jumper Setting
Note: The jumper is factory-set to TC S PT (temperature input).
Set the jumper to temperature, voltage, or current input according to the sensor connected to the input terminal.
After setting the jumper, put on the housing, pressing the housing until the hooks of the front panel snap on.
A--186
I: Current input
approximately 0.29 to 0.39 N S m, or 3 to 4 kgf S cm.
TC S PT: Temperature input
Ramp/Soak Process Controller
V: Voltage input
Adapter
Panel
Watertight packing
Note: Do not touch the pins of the jumper connector when setting the input type.
E5CK- -T