W352-E1-06 Omron, W352-E1-06 Datasheet - Page 69

• Manufacturer Part Number: W352-E1-06
• Description: Product Manual
• Manufacturer: Omron

Installing the CPM2A
Accessibility
3-3
3-3-1 CPM2A Orientation
3-3-2 CPM2A Installation
Surface Installation
50
Installing the CPM2A
Ensure that the CPM2A can be accessed for normal operation and mainte-
nance.
• Provide a clear path to the CPM2A for operation and maintenance. High-volt-
• The PC will be easiest to access if the panel or cabinet is installed about 3 to 5
This section describes how to install the CPM2A and connect Expansion Units
and Expansion I/O Units. Refer to Appendix B for diagrams showing the dimen-
sions of the Units.
The CPM2A must be installed in the position shown below to ensure adequate
cooling.
Do not install the CPM2A in either of the following positions.
The CPM2A can be installed on a horizontal surface or on a DIN track.
Use the following pattern when installing a CPM2A CPU Unit, Expansion Unit, or
Expansion I/O Unit on a vertical surface. (Use M4 dia. x 15 screws.)
The width (A) between the mounting holes depends on the Unit.
CPU Unit with 20/30 I/O terminals
CPU Unit with 40 I/O terminals
age equipment or power lines could be dangerous if they are in the way during
routine operations.
feet above the floor.
100 mm
Four, M4 holes
Incorrect
Unit
Unit
A
Correct
Incorrect
8 mm
120 mm
140 mm
(tolerance: ±0.2 mm)
Width (A)
Section 3-3