RELAY CARD-INT SOLA HEVI DUTY, RELAY CARD-INT Datasheet - Page 24

Manufacturer Part Number

RELAY CARD-INT

Description

Intellislot Relay Card

Manufacturer

SOLA HEVI DUTY

Datasheet

1.RELAY_CARD-INT.pdf (46 pages)

Features

Provides Dry Contact Relay Outputs For Custom Wired Applications And Delivers Support For Built-in Shutdown For AS/400 Systems

Accessory Type

Relay Card

For Use With

S4K5U

Lead Free Status / RoHS Status

7.0

7.1

7.1.1

The final step of installation may require custom configuration of your UPS using the enclosed config-

uration program. Some configuration settings may be changed only while the UPS is off. These should

be set before the UPS is put into full-time service powering the critical load.

For most users operating with 230VAC and with no external batteries, the factory default settings

will be adequate.

S4K5U6000-5 and S4K5U4500-5 Configuration Program Features

What You Will Need

In addition to the S4K5U UPS, you will need the configuration program diskette and serial cable

(beige or tan, 3-wire: GND, TX, RX; straight through 2-2, 3-3, 5-5) included in the UPS accessory box.

A Windows 95® or later computer, desktop or laptop, is also required to set up and run the configura-

tion program.

• Select one of three L-N output voltages to match local voltages.

• Enable/Disable Auto-Restart.

• Select frequency converter operation with a fixed output frequency of 50 or 60 Hz.

• Set the Low Battery Warning alarm time from 2 to 30 minutes.

• Enable/Disable the Auto-Battery test.

• Set the Auto-Battery test to 7, 14, 21, or 28 days.

• Specify the number of external battery cabinets connected to the UPS to adjust the remaining run

• Modify the shutdown setting of DB-9 pin 6 (for information on pin assignments, see Table 2).

ONFIGURATION

time calculations reported by Sola/Hevi-Duty software products.

ROGRAM

Configuration Program