1-6610115-1 Tyco Electronics, 1-6610115-1 Datasheet - Page 2

• Manufacturer Part Number: 1-6610115-1
• Description: CONN 1X4 MAG45 MOD GRN/GRN PCB
• Manufacturer: Tyco Electronics
• Series: Mag45™r

Specifications of 1-6610115-1

• Connector Type: RJ45
• Number Of Ports: 4
• Number Of Rows: 1
• Mounting Type: Panel Mount; Through Hole, Right Angle
• Speed: 10/100 Base-T
• Height Above Board: 0.545" (13.84mm)
• Led Color: Green - Green
• Number Of Cores Per Jack: 4
• Shielding: Shielded
• Tab Direction: Up
• Features: AutoMDIX, Board Lock
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

|
|
|
|
|
|
|
3.2.
3.3.
3.4.
3.5.
3.6.
Rev B
Examination of product.
Dry circuit resistance.
Materials
!
!
!
!
!
Ratings
!
!
!
Product Codes
Product Codes for this product family are H363, H364, H365 and H366
Performance and Test Description
Product is designed to meet the electrical, mechanical and environmental performance requirements
specified in Figure 1. Unless otherwise specified, all tests shall be performed at ambient environmental
conditions per EIA-364.
Test Requirements and Procedures Summary
Test Description
Contacts:
Housing:
LED:
Shield:
Magnetics:
Voltage: 150 volts AC
Current: Signal application only
Temperature:
•
•
Standard: 0 to 70
Extended temperature varieties: -40 to 85
Phosphor bronze, overall nickel plating with selective gold plating in the contact
area and selective tin-lead plating on the soldertails. RoHS compliant versions
will have tin and\or SAC solder dip on the soldertails in place of tin-lead.
High temperature PET molding compound, UL94V-0
Epoxy encapsulated diode lens, steel lead frame with nickel, copper, silver and
tin-lead plating. RoHS compliant versions will have tin and\or SAC solder dip or
tin dip in place of tin-lead.
Brass, semi-bright (satin) nickel plating, selective tin-lead plating on the
soldertails. RoHS compliant versions will have SAC solder dip on the soldertails
in place of tin-lead.
Epoxy encapsulated wound cores and printed circuit board. Printed circuit board
assembly contains common mode choke cores, isolation transformer cores, auto
transformer (center-tapped inductor) cores, resistors, and capacitors with wire
bonded pad connections. Wound cores consist of quadruple polyurethane-nylon
coated fine gage magnet wire wrapped on a manganese-zinc ferrite toroid.
/
C
Meet requirements of product
drawing, and dimensional and
plating requirements of FCC Part
68, Subpart F, Connector
Specification per Figure
68.500(d)(2)(i) 8 Position Series
Modular Jack.
)
See Engineering Report 502-1129.
R 30 milliohms maximum.
Figure 1 (cont)
ELECTRICAL
Requirement
/
C
Measure per drawing, inspect
plating thickness per x-ray
evaluation per EIA-364-48 Method
C.
EIA-364-23A.
Subject specimens to 100 mA
maximum and 20 mV maximum
open circuit voltage.
See Figure 3.
Procedure
108-2100
2 of 7