SNAP-IT-PM-ADS-PLUS OPTO 22, SNAP-IT-PM-ADS-PLUS Datasheet - Page 10

• Manufacturer Part Number: SNAP-IT-PM-ADS-PLUS
• Description: Controllers
• Manufacturer: OPTO 22

Specifications of SNAP-IT-PM-ADS-PLUS

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

The information in this manual has been checked carefully and is believed to be accurate; however, Opto 22 assumes no responsibility for
REMOVING A MODULE
Removing a Module
Notes on Maintenance
10
possible inaccuracies or omissions. Specifications are subject to change without notice. All trademarks, trade names, logos, and service
1267-050202—SNAP-IT-PM Installation Guide
Copyright © 1999–2005 Opto 22. All rights reserved. Printed in the United States of America.
LEDs for Special-Purpose Modules
LEDs are provided on some special-purpose modules, usually to indicate status or diagnostic
information. See the module’s user’s guide for details.
To remove a module from the
SNAP-IT unit, you must use the SNAP
module tool (provided).
Instructions for maintenance are in the SNAP Ethernet-Based I/O Units User’s Guide. If you need
to change the SNAP-IT unit’s IP address, reset it to factory defaults, or download new firmware,
you will need to use instructions in the user’s guide.
1. Unplug power to the SNAP-IT
2. If the modules are held in place
3. Holding the SNAP module tool
4. Squeeze the module tool
5. When you have finished removing and installing modules, replace the small white fuse on
WARNING: Make sure there is
no power to the rack before
continuing, or you may severely
damage the module.
unit. Remove the small white
fuse from the module mounting
rack.
with screws, remove them.
as shown in the illustration at
right, insert it into the notch at
the base of the module.
against the module to open the release latch. Pull straight up on the module to remove it.
the module mounting rack and plug power back into the SNAP-IT unit.
marks referenced herein belong to their respective companies.