DS90CR286MTD National Semiconductor, DS90CR286MTD Datasheet - Page 15

• Manufacturer Part Number: DS90CR286MTD
• Description: IC, LVDS RECEIVER, TSSOP-56
• Manufacturer: National Semiconductor

Specifications of DS90CR286MTD

• Supply Current: 105mA
• Supply Voltage Range: 3V To 3.6V
• Driver Case Style: TSSOP
• No. Of Pins: 56
• Operating Temperature Range: -40°C To +85°C
• Device Type: Differential Receiver
• Termination Type: SMD
• Filter Terminals: SMD
• Rohs Compliant: No
• Data Rate Max: 462Mbps
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Applications Information
number of bypass capacitors, the PLL V
CLOCK JITTER: The CHANNEL LINK devices employ a
PLL to generate and recover the clock transmitted across the
LVDS interface. The width of each bit in the serialized LVDS
data stream is one-seventh the clock period. For example, a
66 MHz clock has a period of 15 ns which results in a data bit
width of 2.16 ns. Differential skew (∆t within one differential
pair), interconnect skew (∆t of one differential pair to an-
other) and clock jitter will all reduce the available window for
sampling the LVDS serial data streams. Care must be taken
to ensure that the clock input to the transmitter be a clean
low noise signal. Individual bypassing of each V
will minimize the noise passed on to the PLL, thus creating a
low jitter LVDS clock. These measures provide more margin
FIGURE 20. CHANNEL LINK
Decoupling Configuration
FIGURE 19. LVDS Serialized Link Termination
CC
(Continued)
should receive
CC
01291025
to ground
15
the most filtering/bypassing. Next would be the LVDS V
pins and finally the logic V
for channel-to-channel skew and interconnect skew as a part
of the overall jitter/skew budget.
COMMON MODE vs. DIFFERENTIAL MODE NOISE MAR-
GIN: The typical signal swing for LVDS is 300 mV centered
at +1.2V. The CHANNEL LINK receiver supports a 100 mV
threshold therefore providing approximately 200 mV of dif-
ferential noise margin. Common mode protection is of more
importance to the system’s operation due to the differential
data transmission. LVDS supports an input voltage range of
Ground to +2.4V. This allows for a
center point due to ground potential differences and common
mode noise.
POWER SEQUENCING AND POWERDOWN MODE: Out-
puts of the CNANNEL LINK transmitter remain in TRI-
STATE
outputs will begin to toggle 10 ms after V
and the Powerdown pin is above 1.5V. Either device may be
placed into a powerdown mode at any time by asserting the
Powerdown pin (active low). Total power dissipation for each
device will decrease to 5 µW (typical).
The CHANNEL LINK chipset is designed to protect itself
from accidental loss of power to either the transmitter or
receiver. If power to the transmit board is lost, the receiver
clocks (input and output) stop. The data outputs (RxOUT)
retain the states they were in when the clocks stopped.
When the receiver board loses power, the receiver inputs are
shorted to V
(5 mA per input) by the fixed current mode drivers, thus
avoiding the potential for latchup when powering the device.
®
until the power supply reaches 2V. Clock and data
CC
through an internal diode. Current is limited
CC
pins.
±
1.0V shifting of the
CC
01291024
has reached 3V
www.national.com
CC