1-2154018-4 TE Connectivity, 1-2154018-4 Datasheet - Page 3

• Manufacturer Part Number: 1-2154018-4
• Description: CONN STRAIGHT RIGHT GREEN ASSY
• Manufacturer: TE Connectivity
• Type: Wire to Boardr

Specifications of 1-2154018-4

• Connector Type: Wire To Board
• Contact Termination: IDC / IDT
• Gender: Plug
• No. Of Contacts: 4
• No. Of Rows: 1
• Pitch Spacing: 2.5mm
• Contact Plating: Tin
• Product: IDC Connector
• Mounting Style: Wire
• Termination Style: IDC
• Current Rating: 1000 mA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: A101448

Rev B
3.3. Materials
The NEVALO housings are made from glass-filled PBT, while the IDC contacts are made from copper alloy with
tin plate over nickel.
3.4. Limitations
The operating temperature range for the NEVALO Interconnect System is -20° to 105°C [-4° to 221°F].
3.5. Special Characteristics
NEVALO Interconnects are available in four colors. Housings have a molded keying feature that corresponds to
keying features on the mating part (clip, driver, etc.) to prevent over/under powering of light modules. See
Figure 1.
3.6. Cable Preparation
The IDC contacts in the NEVALO Interconnects are designed to accept NEVALO ribbon cable stranded tinned
copper conductors. An initial cut needs to be made using a guillotine-type cutting tool. See Figure 2. Contact
your TE Representative for current tool recommendations for cutting and notching of cables.
CAUTION
C. Chemical Exposure
Do not store connectors near any chemicals listed below as they may cause stress corrosion cracking in the
contacts.
NOTE
NOTE
-A-
Alkalies
Amines
i
i
!
A notching procedure is required when a NEVALO Feed-Thru connector is used. Use cable notching tool 2119990-1 to
ensure proper notch size and length. Contact the Product Information Center number at the bottom of page 1 for specific
information on this process or refer to hand tool instruction sheet.
Care must be taken when aligning cable prior to termination to maintain parallelism between the end of the cable and the
inner wall of the connector.
Feed-Thru connectors should not be placed closer than 25 mm apart (centerline-to-centerline) due to tooling constraints.
Printed Circuit Board width may effect minimum spacing.
Cable preparation for
straight, right-angle, and
terminator connectors
Ammonia
Carbonates
Citrates
Nitrites
0.25
A
Sulfur Nitrites
Phosphates Citrates
Figure 2
NOTE: Use notching tool 2119990-1 to sever two
conductors. Notch striped side of ribbon cable for Feed-Thru
Left (FTL) and non-striped side for Feed-Thru Right (FTR).
Cable preparation for feed-thru connector
FTL
Sulfur Compounds
Tartrates
FTR
114-13290
3 of 12