1-2154018-4 TE Connectivity, 1-2154018-4 Datasheet - Page 2

• Manufacturer Part Number: 1-2154018-4
• Description: CONN STRAIGHT RIGHT GREEN ASSY
• Manufacturer: TE Connectivity
• Type: Wire to Boardr

Specifications of 1-2154018-4

• Connector Type: Wire To Board
• Contact Termination: IDC / IDT
• Gender: Plug
• No. Of Contacts: 4
• No. Of Rows: 1
• Pitch Spacing: 2.5mm
• Contact Plating: Tin
• Product: IDC Connector
• Mounting Style: Wire
• Termination Style: IDC
• Current Rating: 1000 mA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: A101448

Rev B
2. REFERENCE MATERIAL
2.1. Revision Summary
2.2. Customer Assistance
Reference Part Number 2154234 and Product Code L895 are representative numbers of the NEVALO
Interconnect System. Use of these numbers will identify the product line and expedite your inquiries through a
service network established to help you obtain product information. Such information can be obtained through a
local TE Representative or, after purchase, by calling the Tooling Assistance Center or the Product Information
Center number at the bottom of page 1.
2.3. Drawings
Customer Drawings for each connector are available from the service network. The information contained in
Customer Drawings takes priority if there is a conflict with this specification or with any technical documentation
supplied by TE.
2.4. Specifications
Design Objective 108-2442 provides expected product performance and test information.
2.5. Instructional Material
Instruction Sheet 408-10413 provides information for the NEVALO Interconnect System Hand Crimping Tool Kit
2161090-1.
3. REQUIREMENTS
3.1. Safety
Do not stack product shipping containers so high that the containers buckle or deform.
3.2. Storage
•
•
•
and Section 4, QUALIFICATIONS
•
A. Ultraviolet Light
Prolonged exposure to ultraviolet light may deteriorate the chemical composition used in the receptacle
connector material.
B. Shelf Life
The connectors should remain in the shipping containers until ready for use to prevent deformation to the
connectors. The connectors should be used on a first in, first out basis to avoid storage contamination.
Updated document to corporate requirements
Added new artwork to Figures 1, 3, 4, 9, and 11
Changed, added, or deleted text in Section 1, INTRODUCTION; Paragraphs 3.7, 3.8, 3.9, 3.9.B.3, 3.10.A;
Added new information to table in Figure 10
Bus-to-Wire Connector
Figure 1 (End)
SMT Driver Header
114-13290
2 of 12