TDA7492MV13TR STMicroelectronics, TDA7492MV13TR Datasheet - Page 25

• Manufacturer Part Number: TDA7492MV13TR
• Description: IC AMP AUD CLASS D BTL PWRSSO36
• Manufacturer: STMicroelectronics
• Type: Class Dr

Specifications of TDA7492MV13TR

• Output Type: 1-Channel (Mono)
• Max Output Power X Channels @ Load: 50W x 1 @ 6 Ohm
• Voltage - Supply: 5 V ~ 18 V
• Features: Depop, Differential Inputs, Mute, Short-Circuit and Thermal Protection, Standby
• Mounting Type: Surface Mount
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-11059-2

TDA7491MV
7.7
7.8
Protection function
The TDA7491MV is fully protected against overvoltages, undervoltages, overcurrents and
thermal overloads as explained here.
Overvoltage protection (OVP)
If the supply voltage exceeds the value for V
page 8
high-impedance state. When the supply voltage drops to below the threshold value the
device restarts.
Undervoltage protection (UVP)
If the supply voltage drops below the value for V
specifications on page 8
the high-impedance state. When the supply voltage recovers the device restarts.
Overcurrent protection (OCP)
If the output current exceeds the value for I
page 8
high-impedance state. Periodically, the device attempts to restart. If the overcurrent
condition is still present then the OCP remains active. The restart time, T
by the R-C components connected to pin STBY.
Thermal protection (OTP)
If the junction temperature, T
the positive and negative PWM outputs are forced to 50% duty cycle. If the junction
temperature exceeds the value for Tj given in
device shuts down and the output is forced to the high impedance state. When the device
cools sufficiently the device restarts.
Diagnostic output
The output pin DIAG is an open drain transistor. When the protection is activated it is in the
high-impedance state. The pin can be connected to a power supply (< 18 V) by a pull-up
resistor whose value is limited by the maximum sinking current (200 µA) of the pin.
Figure 26. Behavior of pin DIAG for various protection conditions
the overvoltage protection is activated which forces the outputs to the
the overcurrent protection is activated which forces the outputs to the
VDD
Overcurrent
protection
the undervoltage protection is activated which forces the outputs to
j
, reaches 145 °C (nominal), the device goes to mute mode and
Protection logic
Doc ID 14576 Rev 2
TDA7491MV
Restart
OCP
OVP
Table 5: Electrical specifications on page 8
given in
given in
UVP
DIAG
given in
VDD
Table 5: Electrical specifications on
Table 5: Electrical specifications on
R1
OV, UV, OT
protection
Table 5: Electrical
Application information
Restart
OC
, is determined
25/28
the