P6021 Tektronix, P6021 Datasheet - Page 7

• Manufacturer Part Number: P6021
• Description: Test Probes 60MHZ, 250A 5 FT, w/term
• Manufacturer: Tektronix

Specifications of P6021

• Color: Black
• Equipment Type: Test Probe Set
• Accessory Type: AC Current Probe
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: AC current measurements

General Safety Summary
P6021 Instruction Manual
To Avoid Fire or
Personal Injury
Review the following safety precautions to avoid injury and prevent damage to
this product or any products connected to it.
To avoid potential hazards, use this product only as specified.
Only qualified personnel should perform service procedures.
Connect and Disconnect Properly. De-energize the circuit under test before
connecting or disconnecting the current probe.
Connect and Disconnect Properly. Connect the probe output to the measurement
instrument before connecting the probe to the circuit under test. Connect the
probe reference lead to the circuit under test before connecting the probe input.
Disconnect the probe input and the probe reference lead from the circuit under
test before disconnecting the probe from the measurement instrument.
Ground the Product. This product is grounded through the grounding conductor
of the power cord. To avoid electric shock, the grounding conductor must be
connected to earth ground. Before making connections to the input or output
terminals of the product, ensure that the product is properly grounded.
Observe All Terminal Ratings. To avoid fire or shock hazard, observe all ratings
and markings on the product. Consult the product manual for further ratings
information before making connections to the product.
Connect the probe reference lead to earth ground only.
Do not apply a potential to any terminal, including the common terminal, that
exceeds the maximum rating of that terminal.
Do not connect a current probe to any wire that carries voltages above the current
probe voltage rating.
Do Not Operate Without Covers. Do not operate this product with covers or panels
removed.
Do Not Operate With Suspected Failures. If you suspect there is damage to this
product, have it inspected by qualified service personnel.
Avoid Exposed Circuitry. Do not touch exposed connections and components
when power is present.
Do Not Operate in Wet/Damp Conditions.
Do Not Operate in an Explosive Atmosphere.
Keep Product Surfaces Clean and Dry.
iii