STTS751-0WB3F STMicroelectronics, STTS751-0WB3F Datasheet - Page 6

• Manufacturer Part Number: STTS751-0WB3F
• Description: Board Mount Temperature Sensors 2.25 V Low-Volt Digital Temp Sensor
• Manufacturer: STMicroelectronics

Specifications of STTS751-0WB3F

• Temperature Threshold: + 125 C
• Full Temp Accuracy: - 40 C to + 125 C
• Package / Case: SOT-23-6L
• Digital Output - Bus Interface: 2 Wire, SMBus
• Digital Output - Number Of Bits: 12 bit
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 2.25 V
• Description/function: Digital Temperature Sensor
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• Supply Current: 50 uA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Description
1
6/36
Description
The STTS751 is a digital temperature sensor which communicates over a 2-wire SMBus 2.0
compatible bus. The temperature is measured with a user-configurable resolution between
9 and 12 bits. At 9 bits, the smallest step size is 0.5 °C, and at 12 bits, it is 0.0625 °C. At the
default resolution (10 bits, 0.25 °C/LSB), the conversion time is nominally 21 milliseconds.
The open-drain EVENT output is used to indicate an alarm condition in which the measured
temperature has exceeded the user-programmed high limit or fallen below the low limit.
When the EVENT pin is asserted, the host can respond using the SMBus Alert Response
Address (ARA) protocol to which the STTS751 will respond by sending its slave address.
The STTS751 is a 6-pin device that supports user-configurable slave addresses. Via the
pull-up resistor on the Addr/Therm pin, one of four different slave addresses can be
specified. Two order numbers (STTS751-0 and STTS751-1) provide two different sets of
slave addresses bringing the total available to eight. Thus, up to eight devices can share the
same 2-wire SMBus without ambiguity, thereby allowing monitoring of multiple temperature
zones in an application.
The two-wire interface can support transfer rates up to 400 kHz. Two small footprint
packages are available: a UDFN-6L and a standard SOT23-6L package.
Figure 1.
1. This pin may not float.
Table 2.
Addr/Therm
Symbol
EVENT
GND
SDA
SCL
V
DD
Logic diagram
Signal names
SCL
SDA
Doc ID 16483 Rev 5
Ground
Output
Output
Power
Type
Input
I/O
STTS751-1
STTS751-0
GND
V DD
Address selection pin / thermal status pin
Event (alert) output
SMBus interface data I/O
SMBus interface clock input
Device power supply
Device ground
EVENT
Addr/Therm
Description
(1)
STTS751
AM03028v1