STTS751-0WB3F STMicroelectronics, STTS751-0WB3F Datasheet - Page 23

• Manufacturer Part Number: STTS751-0WB3F
• Description: Board Mount Temperature Sensors 2.25 V Low-Volt Digital Temp Sensor
• Manufacturer: STMicroelectronics

Specifications of STTS751-0WB3F

• Temperature Threshold: + 125 C
• Full Temp Accuracy: - 40 C to + 125 C
• Package / Case: SOT-23-6L
• Digital Output - Bus Interface: 2 Wire, SMBus
• Digital Output - Number Of Bits: 12 bit
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 2.25 V
• Description/function: Digital Temperature Sensor
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• Supply Current: 50 uA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

STTS751
6
Addr/Therm output
The Addr/Therm pin functions normally as an output to alert the system of an over
temperature condition. It is open drain and requires a pull-up resistor. During power-up, the
pull-up value is sensed by the STTS751 to determine what its slave address will be as
depicted in
The Therm output is asserted low whenever the temperature exceeds the Therm limit
(address 20h). Only the upper 8 bits of the temperature register are used in the
comparison with the Therm limit. Once asserted, Therm will remain asserted until
temperature falls below the Therm limit minus the therm hysteresis value. For example, if
the Therm limit is 25 °C, and the therm hysteresis value is 10 °C, the Therm output will
assert when the temperature exceeds 25 °C. It will remain asserted until the temperature
falls down to or below 15 °C (25 – 10).
This pin can be used to control a fan or other failsafe device as shown in
Figure 7
Figure 7.
Addr/Therm
below shows how the Therm output functions.
Therm Limit minus
Therm Hysteresis
Table
Temperature
Therm output
Therm limit
1.
Doc ID 16483 Rev 5
Hysteresis
Therm
Time
Addr/Therm output
Figure 4 on page
AM03033v1
23/36
8.