BNX002-01 Murata, BNX002-01 Datasheet - Page 202

• Manufacturer Part Number: BNX002-01
• Description: EMI/RFI Suppressors & Ferrites 50V 10A EMI FILTER
• Manufacturer: Murata
• Series: BNXr

Specifications of BNX002-01

• Lead Spacing: 2.5 mm
• Shielding: Unshielded
• Product: EMI Filters
• Impedance: 50 Ohms
• Maximum Dc Current: 10 Amps
• Operating Temperature Range: - 30 C to + 85 C
• Termination Style: Radial
• Length/height, External: 13mm
• Frequency Max: 1GHz
• External Width: 12mm
• Voltage Rating Vdc: 50V
• External Depth: 11mm
• Rohs Compliant: Yes
• Frequency Range: 1MHz To 1GHz
• Dc Current Rating: 10A
• Ferrite Mounting: Through Hole
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

BNX Block Type EMIFILr Lead Type
(3) Cleaner
conditions.
(1) Cleaning temperature should be limited to 60 C max.
(2) Ultrasonic cleaning should comply with the following
!Note
200
(1) Use Sn-3.0Ag-0.5Cu solder.
(2) Use Rosin-based flux. Do not use strong acidic flux with
(3) Products and the leads should not be subjected to any
(4) Standard flow soldering profile
Clean the block Type EMIFILr(Lead Type) in the following
3. Soldering
4. Cleaning
Power: 20W/liter max.
Frequency: 28 to 40kHz
Time: 5 min. max.
(a) Alcohol type cleaner
(b) Aqueous agent
halide content exceeding 0.2wt% (chlorine conversion
value).
mechanical stress during the soldering process, or while
subjected to the equivalent high temperatures.
(40 C max for alcohol type cleaner).
conditions, avoiding the resonance phenomenon at the
mounted products and P.C.B.
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please review our product specifications or consult the approval sheet for product specifications before ordering.
Isopropyl alcohol (IPA)
Pine Alpha ST-100S
Sn-3.0Ag-0.5Cu solder
300
250
200
150
100
50
Solder
Pre-heating
60s min.
150 C
Soldering Temperature Soldering Time
250 to 260˚C
Soldering
Soldering temperature
Soldering Time
Soldering and Mounting
Gradual cooling
(in air)
4 to 6s
(4) There should be no residual flux or residual cleaner left
(5) The surface of products may become dirty after cleaning,
(6) Other cleaning: Please contact us.
after cleaning.
In the case of using aqueous agent, products should be
dried completely after rinsing with de-ionized water in
order to remove the cleaner.
but there is no deterioration on mechanical, electrical
characteristics and reliability.
Mar.28,2011
C31E.pdf