MAX34440ETL+ Maxim Integrated Products, MAX34440ETL+ Datasheet - Page 30

• Manufacturer Part Number: MAX34440ETL+
• Description: Supervisory Circuits PMBUS 6-CH POW SUPPLY MANAGER
• Manufacturer: Maxim Integrated Products

Specifications of MAX34440ETL+

• Minimum Operating Temperature: - 40 C
• Supply Voltage (max): 5.5 V
• Supply Voltage (min): 2.7 V
• Supply Current (typ): 2.5 mA
• Mounting Style: SMD/SMT
• Maximum Operating Temperature: + 85 C
• Package / Case: TQFN-40
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

PMBus 6-Channel Power-Supply Manager
OT_WARN_LIMIT (51h)
The OT_WARN_LIMIT command sets the temperature, in degrees Celsius, of the selected temperature sensor at which
an overtemperature warning is detected. The 2 data bytes are in DIRECT format. In response to the OT_WARN_LIMIT
being exceeded, the device does the following:
1) Sets the TEMPERATURE bit in STATUS_BYTE.
2) Sets the TEMPERATURE and MFR bits in STATUS_WORD.
3) Sets the OT_WARN bit in STATUS_MFR_SPECIFIC.
4) Notifies the host through ALERT assertion (if enabled in MFR_MODE).
POWER_GOOD_ON (5Eh)
The POWER_GOOD_ON command sets the value of the output voltage that causes the PG output to assert. All enabled
power supplies must be above their associated POWER_GOOD_ON thresholds before the PG output is asserted.
All the enabled power supplies must also be above POWER_GOOD_ON for power-supply margining to begin. The
POWER_GOOD_ON level is normally set higher than the POWER_GOOD_OFF level and VOUT_UV_FAULT_LIMIT. The
2 data bytes are in DIRECT format.
OPERATION
COMMAND CODE OR
CONTROL PIN
TON_DELAY
TOFF_DELAY
PSEN PIN
(ACTIVE HIGH OR LOW/
OPEN DRAIN OR PUSH-PULL)
TON_MAX_FAULT_LIMIT
POWER_GOOD_ON
POWER_GOOD_OFF
VOUT_UV_FAULT_LIMIT
ADC INPUT
POWER_GOOD# BIT IN
STATUS_MFR_SPECIFIC
Figure 1. Power-Supply Sequencing
30