RK-WI.232DTS-FCC-R Radiotronix, RK-WI.232DTS-FCC-R Datasheet - Page 8

• Manufacturer Part Number: RK-WI.232DTS-FCC-R
• Description: RF Modules & Development Tools Wi.232DTS-FCC-R RAPID DEV KIT
• Manufacturer: Radiotronix

Specifications of RK-WI.232DTS-FCC-R

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: RK-WI232DTS-FCC-R

WI.232DTS-FCC-R USER’S MANUAL
3. Using the RK-Wi.232DTS-FCC-R
Evaluation Software
The software supplied with the RK-Wi.232DTS-FCC-R RadKit is used to read and set the volatile and non-volatile
registers with the Wi.232DTS module. Refer to the Wi.232DTS Users Manual for more information on the register
settings.
3.1. COM Port Setup and Selection
3.2. Wireless Chat Page
Upon starting the RK-Wi.232DTS-FCC-R evaluation software, you will
be presented with a COM port selection dialog box. If you are using the
USB interface, make sure that the evaluation board is already connected
to the computer via the USB cable before you start the software. This will
ensure that the virtual COM port which is assigned to the USB to UART
bridge controller by Windows is visible in the COM port selection list.
The first time you start the RK-Wi.232DTS-FCC-R evaluation software,
the Baud Rate should be left at 2400 baud, since this is the factory
default baud rate setting for the module.
Tip: The RK-Wi.232DTS-FCC-R evaluation software does not
autodetect the baud rate of the module. If you have changed the Non-
Volatile Data Rate register, you will have to select the baud rate you set
this register to when you start the RK-Wi.232DTS-FCC-R evaluation
software.
The Wireless Chat page in the RK-Wi.232DTS-FCC-R evaluation software demonstrates the capability of the
Wi.232 to be used as a wireless communications link. The Rapid Development kit works as a wireless chat
link with no register changes required, out of the box.
7
Chapter
3