AVR-ISP500-ISO Olimex Ltd., AVR-ISP500-ISO Datasheet - Page 2
![Programmers & Debuggers AVR PROGRAMMER 2MB FLASH 1000V](/photos/15/95/159562/avr-isp500-iso-2_sml.jpg)
AVR-ISP500-ISO
Manufacturer Part Number
AVR-ISP500-ISO
Description
Programmers & Debuggers AVR PROGRAMMER 2MB FLASH 1000V
Manufacturer
Olimex Ltd.
Datasheet
1.AVR-ISP500-ISO.pdf
(15 pages)
Specifications of AVR-ISP500-ISO
Positions/sockets
1
Description/function
USB AVR Programmer
Tool Type
Programmer
Core Architecture
AVR
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With/related Products
AVR Studio
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
INTRODUCTION:
FEATURES:
ELECTROSTATIC WARNING:
REQUIREMENTS:
AVR-ISP500-ISO is professional serial in-system programmer for AVR
microcontrollers, featuring optoisolation between PC and target AVR board.
It implements the STK500v2 protocol as defined by Atmel which makes it
compatible with a range of tools, including
It is distinguished from other programmers by its support for autonomous
operation. AVR-ISP500-ISO contains a 2Mb FLASH memory where it can
store entire programming sessions, including FUSE, LOCK, EEPROM and
FLASH write and verification, as well as signature checking. Just hold the
button, perform all the necessary steps with AvrStudio, and disconnect the
programmer from the PC. Next time button is pressed the programmer will
invoke all previously recorded steps without the need for connection to the
PC. We believe this feature makes AVR-ISP500-ISO the perfect tool for
firmware upgrades in remote places.
-
-
-
-
-
-
-
-
-
-
-
-
-
The AVR-ISP500-ISO board is shipped in protective anti-static packaging.
The board must not be subject to high electrostatic potentials. General
practice for working with static sensitive devices should be applied when
working with this board.
Cables: 1.8 meter USB A-B cable. Ten- or six-wire ribbon cable for
connection to target AVR chip.
Power: External 9-12V DC or 6-9V AC power supply (needed only for
autonomous operation when USB is not plugged).
Software: Software with support for STK500v2 protocol:
Fully STK500v2 compatible;
Works with AvrStudio, WinAVR, Avrdude and every other software
compatible with STK500v2;
USB port for connection to PC;
Opto-isolation 1000VDC between PC and target AVR board allows
programming of targets under high voltages;
Stand alone operation without the need for PC connection, allowing
firmware mass programming on many devices with single button press;
One bi-color LED for current operation status;
One bi-color LED for last autonomous operation status;
Supports both standard ICSP10 and ICSP6 connectors;
Button for initiating autonomous operations and command logging;
Powered either by USB or external AC/DC power supply;
External clock output on ICSP10 pin 3 for rescuing AVRs with enabled
external clock fuse;
Supports target voltages ranging from 1.8V to 5.5V.
ISP clock frequencies ranging from 5kHz to 1.843MHz.
-
-
AvrStudio, available from Atmel.
avrdude, included in the WinAVR distribution.
AvrStudio
and
avrdude
.