OM6274 NXP Semiconductors, OM6274 Datasheet - Page 13

• Manufacturer Part Number: OM6274
• Description: Interface Modules & Development Tools I2C to SPI Master Bridge Demoboard
• Manufacturer: NXP Semiconductors

Specifications of OM6274

• Interface Type: I2C, SPI
• Data Bus Width: 8 bit
• For Use With/related Products: SC18IS602IPW
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

NXP Semiconductors
SC18IS602_602B_603_4
Product data sheet
7.2 External clock input (SC18IS603)
7.3 SPI interface
In this device, the processor clock is derived from an external source driving the CLKIN
pin. The rate may be from 0 Hz up to 18 MHz.
Using the external clock allows higher frequencies from the SPI interface, thus the
SPI Master operating can be up to 4 Mbit/s. The CLKIN frequency does not affect the
clock speed of the I
between bytes on the I
The SPI interface can support Mode 0 through Mode 3 of the SPI specification and can
operate up to 1.8 Mbit/s (SC18IS602/602B) or 4.0 Mbit/s (SC18IS603). The SPI interface
uses at least four pins: SPICLK, MOSI, MISO, and Slave Select (SSn).
SSn are the slave select pins. In a typical configuration, an SPI master selects one SPI
device as the current slave.
There are actually four SSn pins (SS0, SS1, SS2 and SS3) to allow the
SC18IS602/602B/603 to communicate with multiple SPI devices.
The SC18IS602/602B/603 generates the SPICLK (SPI clock) signal in order to send and
receive data. The SCLK, MOSI, and MISO are typically tied together between two or more
SPI devices. Data flows from the SC18IS602/602B/603 (master) to slave on the MOSI pin
(Pin 6) and the data flows from slave to SC18IS602/602B/603 (master) on the MISO pin
(Pin 5).
2
C-bus interface, however, it will have an effect on the low period
2
Rev. 04 — 11 March 2008
C-bus.
SC18IS602/602B/603
I
2
C-bus to SPI bridge
© NXP B.V. 2008. All rights reserved.
13 of 25