D2MQ-1L Omron, D2MQ-1L Datasheet - Page 5

• Manufacturer Part Number: D2MQ-1L
• Description: LEAF LEVER SPDT 2.1OZ/500MA
• Manufacturer: Omron
• Series: D2MQr
• Type: Snap Actionr

Specifications of D2MQ-1L

• Circuit: SPDT
• Switch Function: On-Mom
• Contact Rating @ Voltage: 0.5A @ 30VDC
• Actuator Type: Lever, Straight
• Mounting Type: Chassis Mount
• Termination Style: Solder Lug
• Operating Force: 60gf
• Contact Form: SPDT
• Contact Rating: 0.5 Amp at 30 Volts
• Actuator: Lever, Leaf
• Microswitch Type: Ultra Subminiature
• Actuator Style: Leaf Lever
• Operating Force Max: 60gf
• Contact Voltage Dc Nom: 30V
• Contact Current Max: 500mA
• Switch Terminals: Through Hole
• Circuitry: SPDT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: D2MQ1L; SW146

D2MQ
Precautions
Refer to General Information.
■
Terminal Connections
Make sure that the capacity of the soldering iron is 15 W maxi-
mum (temperature of soldering iron: 300°C max.). Do not take
more than 3 seconds to solder the switch terminal.
If soldering is not carried out under the proper conditions there is
a danger of over-heating and subsequent heat damage
Applying a soldering iron for more than 3 seconds or using one
that is rated at more than 15 W may deteriorate the Switch char-
acteristics.
When soldering the lead wire to the PCB terminal, pay careful
attention so that the flux and solder liquid level does not exceed
the PCB level.
Cat. No. B034-E1-07
Cautions
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS.
To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527.
■
Mounting
Use M1.4 mounting screws with screws to securely mount the
Switch. Tighten the screws to a torque of 0.1 N·m {1 kgf·cm}.
Operation
Do not apply a force more than two times the rated operating
force to the actuator and leaf lever.
Provide an amount of OT that equals or exceeds the standard.
Do not change the operating position by modifying the actuator.
Do not use the Switch in an application where the operating
speed is extremely slow or the actuator is set in the midpoint
between the free position and operating position.
Install the pin plunger switch so that the operating force is applied
in alignment with the stroke of the actuator.
Do not apply a shock to the actuator, otherwise, the Switch may
be damaged.
Do not apply excessive force to the actuator of the Leaf Lever
Switch in the operating, releasing, and horizontal directions.
Separator
When mounting the Switch on a metallic surface, be sure to pro-
vide a Separator between the Switch and mounting plate.
Correct Use
D2MQ
5