PSE531-M5 SMC Corporation of America, PSE531-M5 Datasheet - Page 4

• Manufacturer Part Number: PSE531-M5
• Description: SENSOR VACUUM 101KPA M5 PORT
• Manufacturer: SMC Corporation of America
• Series: PSE530r

Specifications of PSE531-M5

• Pressure Type: Vacuum
• Operating Pressure: -14.65 ~ +0 PSI, -101 ~ 0 kPa
• Port Size: Female, 0.8" (20.32mm) NPT
• Output: Digital
• Voltage - Supply: 12 V ~ 24 V
• Termination Style: Cable with Connector
• Package / Case: Cylinder, Metal
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 606-1020

The front face of the panel mount conforms to IP65
(IP40 when using the
however, there is a possibility of liquid filtration if the
panel mount adapter is not installed securely and
properly. Securely fix the adaptor with screws as
shown below.
When using
16-3-20
Standard
Tighten screws 1/4 to 1/2 turn after the heads are flush with the panel.
Caution
Front protective cover
48 conversion adapter
Series
Specific Product Precautions 2
Be sure to read before handling.
(ZS-26-01)
Mounting
48 conversion adapter
PSE
48 conversion adapter);
Panel mount
(ZS-26-B)
(ZS-26-D)
2-M3 x 8L
1. Connecting sensor cable and connector (ZS-26-E)
2. Connecting power supply/output connection cable
• To connect the power supply/output connection cable to the
Connector
• Cut the sensor cable as shown below.
• Insert each lead wire into the corresponding connector number
• Make sure that the number of connector and the core wire
• Using pliers, snap A into B as shown below so that there is no
• The A and B portion of the sensor connector are already tacked
• To connect the connector to the multi-channel pressure sensor,
• To remove the connector, pull it straight out while applying
C
1
controller, insert the cable connector with the C part facing
down until it clicks.
by following the chart provided below.
color match. After verifying that the wires are inserted all the
way, temporarily hold the connector down manually.
gap between A and B, and secure the connector.
down temporarily at the time of shipment. Do not snap the A
portion in place before inserting the cable. Note that the
connector cannot be taken apart to be reused once it is
crimped. Use a new sensor connector in case wiring or the
snapping of A into B are done incorrectly.
push the connector with its A portion facing toward you into the
socket until it clicks as shown below.
pressure to the fingers on both sides.
no.
1
2
3
4
2
Caution
B
3
Brown (DC+)
Black (Analog output)
Blue (DC–)
N.C.
4
of sensor cable
Core wire color
A
Power supply/Output connector
Sensor connector port
Wiring
2 m
20 mm or more
Verify from the top side of
A that the lead wires are
inserted completely.
Brown
Black
Blue
N.C.
1
2
3
4