STGIPS20K60 STMicroelectronics, STGIPS20K60 Datasheet - Page 15

• Manufacturer Part Number: STGIPS20K60
• Description: IGBT IPM MODULE 17A 600V 25SDIP
• Manufacturer: STMicroelectronics
• Type: IGBTr

Specifications of STGIPS20K60

• Configuration: 3 Phase
• Current: 17A
• Voltage: 600V
• Voltage - Isolation: 2500VDC
• Package / Case: 25-SDIP Module
• Collector-emitter Saturation Voltage: 2.2 V
• Continuous Collector Current At 25 C: 17 A
• Power Dissipation: 42 W
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: Through Hole
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-10573-5

STGIPS20K60
5.1
Recommendations
●
●
●
●
●
●
●
●
Table 13.
Symbol
f
t
V
V
V
PWM
dead
CC
PN
BS
Input signal HIN is active high logic. A 85 kΩ (typ.) pull down resistor is built-in for each
high side input. If an external RC filter is used, for noise immunity, pay attention to the
variation of the input signal level.
Input signal LIN is active low logic. A 720 kΩ (typ.) pull-up resistor, connected to an
internal 5 V regulator through a diode, is built-in for each low side input.
To prevent the input signals oscillation, the wiring of each input should be as short as
possible.
By integrating an application specific type HVIC inside the module, direct coupling to
MCU terminals without any opto-coupler is possible.
Each capacitor should be located as nearby the pins of IPM as possible.
Low inductance shunt resistors should be used for phase leg current sensing.
Electrolytic bus capacitors should be mounted as close to the module bus terminals as
possible. Additional high frequency ceramic capacitor mounted close to the module
pins will further improve performance.
The SD/OD signal should be pulled up to 5 V / 3.3 V with an external resistor (see
Section 4: Smart shutdown function
Control supply voltage Applied between V
High side bias voltage
prevent Arm-short
PWM input signal
Recommended operating conditions
Blanking time to
Supply Voltage
Parameter
Doc ID 16098 Rev 3
Applied between P-Nu,Nv,Nw
Applied between V
i=U,V,W
For each input signal
-40°C < T
-40°C < T
for detailed info).
c
j
< 125°C
< 100°C
Conditions
CC
BOOTi
-GND
-OUT
i
for
Applications information
Min.
13.5
13
1
Value
Typ.
300
15
Max.
400
18
18
20
Unit
15/19
kHz
µs
V
V
V