TDK5100F Infineon Technologies, TDK5100F Datasheet - Page 13

• Manufacturer Part Number: TDK5100F
• Description: TRANSMITTER ASK/FSK SGL TSSOP10
• Manufacturer: Infineon Technologies
• Type: Transmitterr

Specifications of TDK5100F

• Package / Case: 10-TSSOP
• Frequency: 434MHz Center
• Applications: Alarm Systems, Communication Systems
• Modulation Or Protocol: ASK, FSK
• Data Rate - Maximum: 20 kbps
• Power - Output: 3.2dBm
• Current - Transmitting: 7mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Voltage - Supply: 2.1 V ~ 4 V
• Operating Temperature: -25°C ~ 85°C
• Operating Frequency: 435 MHz
• Operating Supply Voltage: 2.5 V, 3.3 V
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Operating Temperature (min): -40C
• Operating Temperature (max): 125C
• Operating Temperature Classification: Automotive
• Operating Supply Voltage (min): 2.1V
• Operating Supply Voltage (typ): 2.5/3.3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Memory Size: -
• Lead Free Status / Rohs Status: Compliant
• Other names: SP000014745; TDK5100F; TDK5100FINTR; TDK5100FXT

2.4
2.4.1
The Phase Locked Loop synthesizer consists of a Voltage Controlled Oscillator (VCO),
an asynchronous divider chain, a phase detector, a charge pump and a loop filter. It is
fully implemented on chip. The tuning circuit of the VCO consisting of spiral inductors
and varactor diodes is on chip, too. Therefore no additional external components are
necessary. The nominal center frequency of the VCO is 868 MHz. The oscillator signal
is fed both, to the synthesizer divider chain and to the power amplifier. The overall
division ratio of the asynchronous divider chain is 64. The phase detector is a Type IV
PD with charge pump. The passive loop filter is implemented on chip.
2.4.2
The crystal oscillator operates at 13.56 MHz.
The crystal frequency is divided by 16. The resulting 847.5 kHz are available at the clock
output CLKOUT (pin1) to drive the clock input of a micro controller.
To achieve FSK transmission, the oscillator frequency can be detuned by a fixed amount
by switching an external capacitor via FSKOUT (pin 4).
The state of the switch is controlled by the signal at FSKDTA (pin 7).
Table 4
FSKDTA (pin7)
Low
Open
1) Low:
2) Open:
3) High:
2.4.3
The VCO frequency is divided by 2 and fed to the Power Amplifier.
The Power Amplifier can be switched on and off
by the signal at ASKDTA (pin 6).
Data Sheet
1)
2)
, High
Functional Block Description
PLL Synthesizer
Crystal Oscillator
Power Amplifier
3)
FSKDTA - FSK Switch
Voltage at pin < 0.5V
Pin open
Voltage at pin > 1.5V
FSK Switch
CLOSED
OPEN
13
Functional Description
V 1.2, 2008-04-04
TDK5100F