AT86RF231-ZF Atmel, AT86RF231-ZF Datasheet - Page 67
![no-image](/images/manufacturer_photos/0/0/78/atmel_sml.jpg)
AT86RF231-ZF
Manufacturer Part Number
AT86RF231-ZF
Description
TXRX LOW POWER 2.4GHZ 32VQFN
Manufacturer
Atmel
Datasheet
1.AT86RF231-ZUR.pdf
(198 pages)
Specifications of AT86RF231-ZF
Frequency
2.4GHz
Data Rate - Maximum
2Mbps
Modulation Or Protocol
802.15.4 Zigbee, 6LoWPAN, RF4CE, SP100, WirelessHART™, ISM
Applications
Industrial Monitoring and Control, Wireless Alarm and Security Systems
Power - Output
-17dBm ~ 3dBm
Sensitivity
-101dBm
Voltage - Supply
1.8 V ~ 3.6 V
Current - Receiving
12.3mA
Current - Transmitting
14mA
Data Interface
PCB, Surface Mount
Antenna Connector
PCB, Surface Mount
Operating Temperature
-40°C ~ 85°C
Package / Case
32-VQFN Exposed Pad, 32-HVQFN, 32-SQFN, 32-DHVQFN
Number Of Receivers
1
Number Of Transmitters
1
Wireless Frequency
2405 MHz to 2480 MHz
Interface Type
SPI
Noise Figure
6 dB
Output Power
20 dB
Operating Supply Voltage
1.8 V to 3.6 V
Maximum Operating Temperature
+ 85 C
Mounting Style
SMD/SMT
Maximum Supply Current
12.3 mA
Minimum Operating Temperature
- 40 C
Modulation
OQPSK
Protocol Supported
802.15.4
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Memory Size
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
- Current page: 67 of 198
- Download datasheet (5Mb)
7.2.5
8111C–MCU Wireless–09/09
Interrupt Handling
or TRAC_STATUS = SUCCESS_DATA_PENDING if the frame pending subfield of the received
ACK frame was set to 1.
The interrupt handling in the Extended Operating Mode is similar to the Basic Operating Mode,
refer to
setting the appropriate bit in register 0x0E (IRQ_MASK).
For RX_AACK and TX_ARET the following interrupts inform about the status of a frame recep-
tion and transmission:
Table 7-13.
RX_AACK
For RX_AACK it is recommended to enable IRQ_3 (TRX_END). This interrupt is issued only if a
frame passes the frame filtering, refer to
valid FCS. This is in contrast to Basic Operating Mode, refer to
on page
On reception of a valid PHR an IRQ_2 (RX_START) is issued. IRQ_5 (AMI) indicates address
match, refer to filter rules in
a frame reception with a valid FCS is indicated by interrupt IRQ_3 (TRX_END).
Thus, it can happen that an IRQ_2 (RX_START) and/or IRQ_5 (AMI) are issued, but no IRQ_3
(TRX_END) interrupt.
TX_ARET
In TX_ARET interrupt IRQ_3 (TRX_END) is only issued after completing the entire TX_ARET
transaction.
Acknowledgement frames do not issue IRQ_5 (AMI) or IRQ_3 (TRX_END) interrupts.
All other interrupts as described in
Extended Operating Mode.
Mode
RX_AACK
TX_ARET
Both
Section 7.1.3 “Interrupt Handling” on page
38. The use of the other interrupts is optional.
Interrupt
IRQ_2 (RX_START)
IRQ_5 (AMI)
IRQ_3 (TRX_END)
IRQ_3 (TRX_END)
IRQ_0 (PLL_LOCK)
Interrupt Handling in Extended Operating Mode
Section 7.2.3.5 “Frame Filtering” on page
Description
Indicates a PHR reception
Issued at address match
Signals completion of RX_AACK transaction if successful
-
-
Signals completion of TX_ARET transaction
Entering RX_AACK_ON or TX_ARET_ON state from
TRX_OFF state, the PLL_LOCK interrupt signals that the
transaction can be started
Section 6.6 “Interrupt Logic” on page
A received frame must pass the address filter
The FCS is valid
Section 7.2.3.5 “Frame Filtering” on page 61
38. The microcontroller enables interrupts by
Section 7.1.3 “Interrupt Handling”
61, and the completion of
29, are also available in
AT86RF231
and has a
67
Related parts for AT86RF231-ZF
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![ATSTK600](/photos/9/20/92038/atstk600_tmb.jpg)
Part Number:
Description:
DEV KIT FOR AVR/AVR32
Manufacturer:
Atmel
Datasheet:
![U641B](/images/manufacturer_photos/0/0/79/atmel_corporation_tmb.jpg)
Part Number:
Description:
INTERVAL AND WIPE/WASH WIPER CONTROL IC WITH DELAY
Manufacturer:
ATMEL Corporation
Datasheet:
![U4082B](/images/manufacturer_photos/0/0/79/atmel_corporation_tmb.jpg)
Part Number:
Description:
Low-Voltage Voice-Switched IC for Hands-Free Operation
Manufacturer:
ATMEL Corporation
Datasheet:
![U4089B](/images/manufacturer_photos/0/0/79/atmel_corporation_tmb.jpg)
Part Number:
Description:
MONOLITHIC INTEGRATED FEATUREPHONE CIRCUIT
Manufacturer:
ATMEL Corporation
Datasheet:
![U4255BM-M](/images/manufacturer_photos/0/0/79/atmel_corporation_tmb.jpg)
Part Number:
Description:
AM-FM Receiver IC U4255BM-M
Manufacturer:
ATMEL Corporation
Datasheet:
![U4089B-P](/images/manufacturer_photos/0/0/79/atmel_corporation_tmb.jpg)
Part Number:
Description:
Monolithic Integrated Feature Phone Circuit
Manufacturer:
ATMEL Corporation
Datasheet:
![TDA4470](/images/manufacturer_photos/0/0/79/atmel_corporation_tmb.jpg)
Part Number:
Description:
Multistandard Video-IF and Quasi Parallel Sound Processing
Manufacturer:
ATMEL Corporation
Datasheet:
![ATF22V10B-25PC](/images/manufacturer_photos/0/0/79/atmel_corporation_tmb.jpg)
Part Number:
Description:
High-performance EE PLD
Manufacturer:
ATMEL Corporation
Datasheet:
![AT89C51ED2-IM](/images/manufacturer_photos/0/0/79/atmel_corporation_tmb.jpg)
Part Number:
Description:
8-bit Flash Microcontroller
Manufacturer:
ATMEL Corporation
Datasheet:
![AT24C01](/images/manufacturer_photos/0/0/79/atmel_corporation_tmb.jpg)
Part Number:
Description:
2-Wire Serial EEPROM
Manufacturer:
ATMEL Corporation
Datasheet: