XBP09-XCUIT-009 Digi International, XBP09-XCUIT-009 Datasheet - Page 26

• Manufacturer Part Number: XBP09-XCUIT-009
• Description: XBEE-PRO XSC -100MW 9.6KBPS
• Manufacturer: Digi International
• Series: XBEE-PRO™r

Specifications of XBP09-XCUIT-009

• Frequency: 910MHz ~ 918MHz
• Data Rate - Maximum: 9.6kbps
• Modulation Or Protocol: FHSS
• Power - Output: 20dBm (100mW)
• Sensitivity: -106dBm
• Voltage - Supply: 3 V ~ 3.6 V
• Current - Receiving: 65mA
• Current - Transmitting: 265mA
• Data Interface: PCB, Through Hole
• Antenna Connector: U.FL
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Applications: -
• Memory Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 602-1132; Q4197953; XBP09-XCUIT-009

XBee‐PRO® XSC OEM RF Modules
Command Summary
AT Command:
ATFL
Binary
Command:
0x07 (7
decimal)
Parameter
Range: 0 – 1
Parameter Value
Default
Parameter
Value: 0
Number of
bytes
returned: 1
Command Summary
AT Command: ATFR
Binary Command: Not available
Command Summary
AT Command: ATFT
Binary Command: 0x24 (36 decimal)
Parameter Range:0 – (DI buffer size minus
0x11 bytes)
Default Parameter Value: DI Buffer size
minus 0x11 (17 decimal)
Number of bytes returned: 2
Minimum Firmware Version Required:
4.27B
0
1
Disable software
Enable software
Configuration
flow control
flow control
FL (Software Flow Control) Command
FR (Force Reset) Command
FT (Flow Control Threshold) Command
© 2010 Digi International, Inc.
Description
<Serial Interfacing> FL Command
is used to configure software flow
control. Hardware flow control is
implemented with the Module as
the DO2 pin (), which regulates
when serial data can be transferred
to the module. FL Command can be
used to allow software flow control
to also be enabled. XON character
used is 0x11 (17 decimal). XOFF
character used is 0x13 (19
decimal).
Description
Description
<Serial Interfacing> Flow Control
Threshhold - Set or read flow control
threshhold. De-assert CTS and/or send
XOFF when FT bytes are in the UART
receive buffer. Re-assert CTS when less
than FT - 16 bytes are in the UART receive
buffer.
<Special> FR command is used in order
to reset the module through the UART.
The characters “OK”<CR> will be
returned and the module will reset
100ms
26