XBP09-XCUIT-009 Digi International, XBP09-XCUIT-009 Datasheet - Page 22

• Manufacturer Part Number: XBP09-XCUIT-009
• Description: XBEE-PRO XSC -100MW 9.6KBPS
• Manufacturer: Digi International
• Series: XBEE-PRO™r

Specifications of XBP09-XCUIT-009

• Frequency: 910MHz ~ 918MHz
• Data Rate - Maximum: 9.6kbps
• Modulation Or Protocol: FHSS
• Power - Output: 20dBm (100mW)
• Sensitivity: -106dBm
• Voltage - Supply: 3 V ~ 3.6 V
• Current - Receiving: 65mA
• Current - Transmitting: 265mA
• Data Interface: PCB, Through Hole
• Antenna Connector: U.FL
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Applications: -
• Memory Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 602-1132; Q4197953; XBP09-XCUIT-009

XBee‐PRO® XSC OEM RF Modules
Command Summary
AT Command: ATBT
Binary Command: 0x04 (4 decimal)
Parameter Range:2 – 0xFFFF
Default Parameter Value: 0x0A (10
decimal)
Number of bytes returned: 2
Related Commands: AT (Guard Time
After), CC (Command Sequence
Character)
Command Summary
AT Command: ATCC
Binary Command: 0x13 (19 decimal)
Parameter Range: 0x20 – 0x7F
Default Parameter Value: 0x2B (ASCII “+”
sign)
Number of bytes returned: 1
Related Commands: AT (Guard Time
After), BT (Guard Time Before)
AT Command: ATCD
Binary Command: 0x28 (40 decimal)
Parameter Range: 0 – 3
Default Parameter Value: 0
Number of bytes returned: 1
Parameter
[x 100 milliseconds]
Value
0
1
2
3
4
addressed to module is sent
Assert only when packet
BT (Guard Time Before) Command
CC (Command Sequence Character) Command
CD (DO3 Configuration) Command
Table 3‐02. Parameter Sent vs. Parameter Stored
Configuration
© 2010 Digi International, Inc.
Default high
Default low
(reserved)
RX LED
BD Parameter Sent (HEX)
E100
12C
0
4
6
Description
Description
<Command Mode Options> BT
Command is used to set the DI pin
silence time that must precede the
command sequence character (CC
Command) of the AT Command Mode
Sequence. Refer to the AT Commands
section [p] to view the default AT
Command Mode Sequence.
<Command Mode Options> CC
Command is used to set the ASCII
character to be used between Guard
Times of the AT Command Mode
Sequence (BT+ CC + AT). The AT
Command Mode Sequence activates AT
Command Mode (from Idle Mode).
Refer to the AT Commands section [p] to
view the default AT Command Mode
Sequence.
Description
<Command Mode
Options> CD
Command is used to
define the behavior of
the DO3/RX LED line.
Interface Data Rate (bps)
19,200
57600
57600
1200
300
BD Parameter Stored (HEX)
E883
12B
0
4
6
22