XB24-BCIT-004 Digi International/Maxstream, XB24-BCIT-004 Datasheet - Page 34

• Manufacturer Part Number: XB24-BCIT-004
• Description: MODULE 802.15.4 SER 2 CHIP ANT
• Manufacturer: Digi International/Maxstream
• Series: XBee™r

Specifications of XB24-BCIT-004

• Frequency: 2.4GHz
• Data Rate - Maximum: 250kbps
• Modulation Or Protocol: 802.15.4
• Applications: Home/Building Automation, Industrial Control, ZigBee™
• Power - Output: 2 mW (3 dBm)
• Sensitivity: -96dBm
• Voltage - Supply: 2.1 V ~ 3.6 V
• Current - Receiving: 38mA
• Current - Transmitting: 35mA
• Data Interface: PCB, Through Hole
• Antenna Connector: On-Board, Chip
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -

XBee ZNet 2.5/XBee‐PRO ZNet 2.5 ZigBee OEM RF Modules v1.x4x
4.2.2. Application-layer Addressing
Broadcast Addressing
Broadcast transmissions are sent using a 64-bit address of 0x0000FFFF. Any RF module in the PAN
will accept a packet that contains a broadcast address. When configured to operate in Broadcast
Mode, receiving modules do not send ACKs (Acknowledgements).
To send a broadcast packet to all modules
NOTE: When programming the module, parameters are entered in hexadecimal notation (without
the “0x” prefix). Leading zeros may be omitted.
Refer to the “Broadcast Transmissions” for more information.
Application-layer addressing allows the application to specify endpoint and cluster ID values for
each transmission. Addressing multiple endpoints and cluster IDs can be accomplished by
explicitly setting these values as needed.
In AT firmware, application-layer addressing must be enabled using the ZA command. When
application-layer addressing is enabled, the DE and SE commands specify the source and
destination endpoints, and the CI command sets the cluster ID that will be used in the
transmission.
In API firmware, the Explicit Addressing ZigBee Command frame (0x11) can be used to configure
the endpoint and cluster ID addressing parameters as needed. The destination device can indicate
application-layer addressing information depending on the AO parameter. Some endpoint values
are reserved for use by the XBee ZNet 2.5 modules and should not be used. Please refer to the
following tables for these values:
Table 4‐04. XBee ZNet 2.5 Endpoint allocation
0xEF (239) - 0xF0 (240)
© 2008 Digi International, Inc.
Set the Destination Addresses of the transmitting module as shown below:
AT Firmware
DL (Destination Low Address) = 0x0000FFFF
DH (Destination High Address) = 0x00000000
API Firmware
Set the 64-bit destination address field in the API transmit frame to 0x000000000000FFFF.
0xDC (220) - 0xEE
0x01 - 0xDB (219)
Endpoint
0xE6 (230)
0xE8 (232)
(238)
0
ZigBee Device Objects endpoint. Reserved for ZigBee stack.
Reserved for Ember Use
Reserved for Digi Use
Command Endpoint
Available endpoints
Description
Data Endpoint
33