BR-EVAL2.0 BlueRadios Inc, BR-EVAL2.0 Datasheet - Page 41

• Manufacturer Part Number: BR-EVAL2.0
• Description: EVAL KIT BLUETOOTH VER2.0
• Manufacturer: BlueRadios Inc
• Type: Bluetooth V 2.0r

Specifications of BR-EVAL2.0

• Frequency: 2.4GHz
• For Use With/related Products: Bluetooth
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 822-1001

SW25
7173 S. Havana Street, Suite 600
Factory Default: Response Type = 0, Security = 0, Auto SCO = 0, Filter = 0
EXAMPLE:
Read Using: ATSI,6
Notes:
WRITE CONNECTION, COMM, UNCONNECTED UART, DEFAULT SERVICE MODES
**Warning**
in “Fast Data Mode” and “ignore UART while unconnected” is to apply 3.3Vdc on
PIO(4) during initial power up for >2 sec.
have no control over the source of streaming data into the radio, or you do
not know when the radio has made a Bluetooth connection, and do not plan on
TYPE :
REPLY:
*Security: 56bit encryption is automatically enabled when set to 1.
UART will reply PAIRED,<BT Address> before the CONNECT,<BT Address> is
returned when a connection is made.
Auto SCO:
**Minor Filter:
See Appendix B for differences between short response and long response
mode.
Requires a reset for security to go into affect.
*If security is enabled in multipoint mode, all connected slaves will
have to use the same PIN.
to each slave.
**With the minor filter enabled, inquiry results are filtered by the
lower 2 bytes of the COD.
are found.
1 = Short Response
2 = No Verbose Mode (No unsolicited responses will be output)
0 = No Authorization
1 = Authorization Required
0 = No Automatic SCO Connect
1 = SCO Auto Connect Upon Radio Connect.
0 = Disable Minor COD Filter on Inquiry
1 = Enable Minor COD Filter on Inquiry
ATSW24,0,0,0,0<cr>
<cr_lf>OK<cr_lf>
OR
<cr_lf>ERROR<cr_lf>
-
-
-
The only way to communicate to the radio after setting the radio
No OKs will come back, but requested information such as ATSI,
ATRSW, ATRSN and ATDI responses will.
The radio will not output CONNECT or DISCONNECT messages.
In FTP and OPP modes the radio will still output all necessary
messages such as PUSH START and PUSH COMPLETE.
www.BlueRadios.com
•
Englewood, CO 80112
Copyright © 2002-2008
BlueRadios, Inc.
Page 41 of 103
There is no way to assign an individual PIN
If the minor filter is disabled all devices
•
Tel [phone]
These settings are used if you
BR-AT_COMMANDS-100 Rev. 3.6.2.1.4.0
•
[e-mail]