ATAVRRZ600 Atmel, ATAVRRZ600 Datasheet - Page 16

• Manufacturer Part Number: ATAVRRZ600
• Description: AVR TXRX EVAL KIT
• Manufacturer: Atmel
• Series: AVR®r
• Type: Transceiver, Microcontrollerr

Specifications of ATAVRRZ600

• Design Resources: RZ600 Radio Schematics RZ600 USB Adapter Schematics
• Frequency: 700MHz, 800MHz, 900MHz, 2.4GHz
• Wireless Frequency: 700 MHz to 2.4 GHz
• Interface Type: USB
• Antenna: SMA
• For Use With/related Products: AT86RF
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: ATRZ600; ATRZ600

7.5 Programming the Example Application
8 Appendix
8.1 FCC Statements
8.1.1 Equipment usage
8.1.2 Compliance Statement (Part 15.19)
8.1.3 Warning (Part 15.21)
8.1.4 Compliance Statement (Part 15.105(b) )
16
AVR600
This step is only required for doing application development on the RZ600 kit.
1. Connect either a JTAG ICE mkII or AVRONE! to your compter.
2. Go through the driver installation. Let the PC select the best USB driver for the
3. Solder the 50 mil 10-pin connector to one of the processor board.
4. Mount a 100mil to 50mil adapter to the debugger and connect the probe to the
5. Use AVR32 Studio or IAR Embedded Workbench to develop and debug programs.
This equipment is for use by developers for evaluation purposes only and must not be
incorporated into any other device or system.
These devices comply with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. These devices may not cause harmful interference, and
2. These devices must accept any interference received, including interference that
Changes or modifications not expressly approved by Atmel Norway could void the
user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
attached debugger. The AVR USB program takes care of this in the background.
freshly soldered connector.
may cause undesired operation.
receiver is connected.
8293A-AVR-03/10