ATAM893T-TKS Atmel, ATAM893T-TKS Datasheet - Page 65

• Manufacturer Part Number: ATAM893T-TKS
• Description: IC MON TIRE-PRESS ATARX9X SER
• Manufacturer: Atmel
• Series: MARC4r

Specifications of ATAM893T-TKS

• Core Processor: MARC4
• Core Size: 4-Bit
• Speed: 4MHz
• Connectivity: SSI (2-Wire, 3 Wire)
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 16
• Program Memory Size: 4KB (4K x 8)
• Program Memory Type: EEPROM
• Eeprom Size: 64 x 16
• Ram Size: 256 x 4
• Voltage - Supply (vcc/vdd): 1.8 V ~ 6.5 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 20-SOIC (5.3mm Width), 20-SO, 20-SOEIAJ
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Data Converters: -

5.3.4.5
4680C–4BMCU–01/05
9-bit Shift Mode
In the 9-bit shift mode, the SSI is able to handle the MCL protocol (described below). It always
operates as an MCL master device, i.e., SC is always generated and output by the SSI. Both the
MCL start and stop conditions are automatically generated whenever the SSI is activated or
deactivated by the SIR bit. In accordance with the MCL protocol, the output data is always
changed in the clock low phase and shifted in on the high phase.
Before activating the SSI (SIR = 0) and commencing an MCL dialog, the appropriate data direc-
tion for the first word must be set using the SDD control bit. The state of this bit controls the
direction of the data port (BP43 or MCL_SD). Once started, the 8 data bits are, depending on
the selected direction, either clocked into or out of the shift register. During the 9th clock period,
the port direction is automatically switched over so that the corresponding acknowledge bit can
be shifted out or read in. In transmit mode, the acknowledge bit received from the slave device is
captured in the SSI Status Register (TACK) where it can be read by the controller. In receive
mode, the state of the acknowledge bit to be returned to the slave device is predetermined by
the SSI Status Register (RACK).
Changing the directional mode (TX/RX) should not be performed during the transfer of an MCL
telegram. One should wait until the end of the telegram which can be detected using the SSI
interrupt (IFN = 1) or by interrogating the ACT status.
Once started, a 9-bit telegram will always run to completion and will not be prematurely termi-
nated by the SIR bit. So, if the SIR bit is set to ‘1’ in telegram, the SSI will complete the current
transfer and terminate the dialog with an MCL stop condition.
Figure 5-42. Example of MCL Transmit Dialog
(IFN = 0)
(IFN = 1)
Interrupt
Interrupt
SRDY
SDD
ACT
SIR
SC
SD
Write STB
(tx data 1)
Start
msb
7 6 5 4 3 2 1
tx data 1
lsb
0 A
Write STB
(tx data 2)
msb
7 6 5 4 3 2 1 0 A
tx data 2
lsb
ATAM893-D
Stop
65