ATTINY15L-1PI Atmel, ATTINY15L-1PI Datasheet - Page 61

• Manufacturer Part Number: ATTINY15L-1PI
• Description: IC AVR MCU 1K FLASH 2.7V 8DIP
• Manufacturer: Atmel
• Series: AVR® ATtinyr

Specifications of ATTINY15L-1PI

• Core Processor: AVR
• Core Size: 8-Bit
• Speed: 1.6MHz
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 6
• Program Memory Size: 1KB (512 x 16)
• Program Memory Type: FLASH
• Eeprom Size: 64 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-DIP (0.300", 7.62mm)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Ram Size: -
• Connectivity: -

Data Polling
1187H–AVR–09/07
When a byte is being programmed into the Flash or EEPROM, reading the address
location being programmed will give the value $FF. At the time the device is ready for a
new byte, the programmed value will read correctly. This is used to determine when the
next byte can be written. This will not work for the value $FF so when programming this
value, the user will have to wait for at least t
Flash byte, or t
tains $FF in all locations, programming of addresses that are meant to contain $FF can
be skipped. This does not apply if the EEPROM is reprogrammed without chip-erasing
the device. In that case, data polling cannot be used for the value $FF and the user will
have to wait at least t
t
Figure 34. Low-voltage Serial Programming Waveforms
WD_PROG_FL
SERIAL DATA OUTPUT
SERIAL CLOCK INPUT
SERIAL DATA INPUT
PB0(MOSI)
PB1(MISO)
PB2(SCK)
and t
WD_PROG_EE
WD_PROG_EE
WD_PROG_EE
MSB
MSB
before the next EEPROM byte. As a chip-erased device con-
values.
before programming the next byte. See Table 30 for
WD_PROG_FL
before programming the next
ATtiny15L
LSB
LSB
61