AT89LP216-20PU Atmel, AT89LP216-20PU Datasheet - Page 72

• Manufacturer Part Number: AT89LP216-20PU
• Description: MCU 8051 2K FLASH 20MHZ 16-PDIP
• Manufacturer: Atmel
• Series: 89LPr

Specifications of AT89LP216-20PU

• Core Processor: 8051
• Core Size: 8-Bit
• Speed: 20MHz
• Connectivity: SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 14
• Program Memory Size: 2KB (2K x 8)
• Program Memory Type: FLASH
• Ram Size: 128 x 8
• Voltage - Supply (vcc/vdd): 2.4 V ~ 5.5 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 16-DIP (0.300", 7.62mm)
• Processor Series: AT89x
• Core: 8051
• Data Bus Width: 8 bit
• Data Ram Size: 128 B
• Interface Type: UART, SPI
• Maximum Clock Frequency: 20 MHz
• Number Of Programmable I/os: 14
• Number Of Timers: 2
• Operating Supply Voltage: 2.4 V to 5.5 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: Through Hole
• 3rd Party Development Tools: PK51, CA51, A51, ULINK2
• Development Tools By Supplier: AT89ISP
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Data Converters: -
• Lead Free Status / Rohs Status: Details

24.8
24.8.1
24.8.2
72
Programming Interface Timing
AT89LP216
Power-up Sequence
Power-down Sequence
This section details general system timing sequences and constraints for entering or exiting In-
System Programming as well as parameters related to the Serial Peripheral Interface during
ISP. The general timing parameters for the following waveform figures are listed in Section
24.8.6 “Timing Parameters” on page
Execute this sequence to enter programming mode immediately after power-up. In the RST pin
is disabled or if the ISP Fuse is disabled, this is the only method to enter programming (see
tion 10.3 “External Reset” on page
Figure 24-5. Serial Programming Power-up Sequence
Execute this sequence to power-down the device after programming.
Figure 24-6. Serial Programming Power-down Sequence
1. Apply power between VCC and GND pins. RST should remain low.
2. Wait at least t
3. Wait at least t
4. Start programming session.
1. Drive SCK low.
2. Wait at least t
3. Tristate MOSI.
4. Wait at least t
5. Wait no more than t
depend on the current settings of the device.
MISO
MOSI
MISO
MOSI
RST
SCK
V
RST
SCK
V
SS
CC
SS
CC
t
SSD
PWRUP
SUT
SSD
SSZ
and then tristate SS and SCK.
for the internal Power-on Reset to complete. The value of t
and bring SS high.
. and drive SS high.
PWRDN
t
PWRUP
and power off VCC.
15).
t
SSZ
75.
HIGH Z
HIGH Z
HIGH Z
HIGH Z
t
POR
+ t
SUT
t
PWRDN
t
ZSS
3621E–MICRO–11/10
SUT
will
Sec-