AT89C51CC03U-RDRIM Atmel, AT89C51CC03U-RDRIM Datasheet - Page 23

• Manufacturer Part Number: AT89C51CC03U-RDRIM
• Description: IC 8051 MCU FLASH 64K 64VQFP
• Manufacturer: Atmel
• Series: AT89C CANr

Specifications of AT89C51CC03U-RDRIM

• Core Processor: 8051
• Core Size: 8-Bit
• Speed: 40MHz
• Connectivity: CAN, SPI, UART/USART
• Peripherals: POR, PWM, WDT
• Number Of I /o: 36
• Program Memory Size: 64KB (64K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 2K x 8
• Ram Size: 2.25K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: External
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-TQFP, 64-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: AT89C51CC03URDRTR

In-Application
Programming/S
elf
Programming
API Call
Process
Constraints
4251B–CAN–03/08
The IAP allows to reprogram a microcontroller on-chip Flash memory without removing it from
the system and while the embedded application is running.
The user application can call Application Programming Interface (API) routines allowing IAP.
These API are executed by the bootloader.
To call the corresponding API, the user must use a set of Flash_api routines which can be linked
with the application.
Example of Flash_api routines are available on the Atmel web site on the software package:
C Flash Drivers for the AT89C51CC03CA for Keil Compilers
The flash_api routines on the package work only with the CAN bootloader.
The flash_api routines are listed in APPENDIX-2.
The application selects an API by setting the 4 variables available when the flash_api library is
linked to the application.
These four variables are located in RAM at fixed address:
•
•
•
•
All calls are made through a common interface “USER_CALL” at the address FFC0h.
The jump at the USER_CALL must be done by LCALL instruction to be able to comeback in the
application.
Before jump at the USER_CALL, the bit ENBOOT in AUXR1 register must be set.
The interrupts are not disabled by the bootloader.
Interrupts must be disabled by user prior to jump to the USER_CALL, then re-enabled when
returning.
Interrupts must also be disabled before accessing EEPROM Data then re-enabled after.
The user must take care of hardware watchdog before launching a Flash operation.
For more information regarding the Flash writing time see the AT89C51CC03 datasheet.
api_command: 1Ch
api_value: 1Dh
api_dph: 1Eh
api_dpl: 1Fh
AT89C51CC03 CAN Bootloader
23