JBXER0G07FSSDPR Souriau Connection Technology, JBXER0G07FSSDPR Datasheet - Page 17

• Manufacturer Part Number: JBXER0G07FSSDPR
• Description: CONN RCPT 7POS FRONT PNL MNT SLD
• Manufacturer: Souriau Connection Technology
• Series: JBXr

Specifications of JBXER0G07FSSDPR

• Connector Type: Receptacle, Female Sockets
• Number Of Positions: 7
• Mounting Type: Panel Mount, Bulkhead - Rear Side Nut
• Termination: Solder
• Fastening Type: Push-Pull
• Orientation: G
• Shell Material, Finish: Brass, Chrome over Nickel
• Features: Shielded
• Connector Body Material: Brass
• Gender: Receptacle
• Contact Gender: Socket
• Connector Mounting: Panel
• Product Type: Connectors
• Shell Style: Receptacle
• Number Of Contacts: 7
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Ingress Protection: -
• Shell Size, Military: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: JBXER0G07FSSDPR; SOU1625

Wiring and assembly
instructions :
90° ELBOW PLUG
• Connector preparation
• Contacts wiring : crimp contacts
• Contacts wiring : solder contacts
• Connector assembly : 90 degree plug
Fixed solder contacts 0.5 mm and 0.7 mm
1 - Insert wire into solder cup and solder.
Braid
Milled flats A
JBX Series
2 - Insert contact into the insulator until the clip is fully seated and cannot be removed.
18
1 - Select the proper crimping tool and locator. (see page 48)
2 - Adjust the crimping tool based on wire size “AWG”. (See wire size and
3 - Crimp the contacts
1 - Select the proper collet (see page 19).
2 - Slide the protective boot
3 - If a shielded cable is used, fold the braid back over the collet
4 - Align the keys in the elbow outlet
5 - Apply thread lock to the backnut
6 - Install the back nut
Removable solder contacts from 0.9 mm to 2 mm
crimp tool settings on the back of the locator)
clip is fully seated and cannot be removed.
outlet
1 - Insert wire into solder cup and solder.
over the cable. Strip end of cable (see pg. 17).
1 - Position the ring
2 - Align the key on the insulator
3 - Insert the insulator sub-assembly into the connector
4 - Apply thread lock to retaining nut
5 - Tighten the retaining nut
on the spacer
spacer.
housing
are facing the retaining nut
torque on page 19.
then insert the contact into the insulator until the
and tighten until it bottoms.
, the backnut
insuring the flats on the elbow outlet
and insert the insulator into the
.
over the insulator.
with the key slot in the collet.
, the collet
to the recommended
.
with the key way
.
and the elbow
.