1055449-1 Tyco Electronics, 1055449-1 Datasheet - Page 3

• Manufacturer Part Number: 1055449-1
• Description: PLIERS RETAINING RING
• Manufacturer: Tyco Electronics

Specifications of 1055449-1

• Tool Type: Pliers
• Product: Accessories
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Features: -
• Length: -
• Tip - Type: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Rev O
CAUTION
For 3.58
[.141] Cable
Fixture Frame
NOTE
For 2.16
[.085] Cable
Center contact holders contains small amounts of
lead. The lead is used for assembly.
Maximum operating temperature for the center
contact holder is 300 _ C [572 _ F]
Figure 5
Thumb
Screw
Trimming
Holes
Solder Assembly Kit 1055466–1
For 1.78
[.070] Cable
Cable
Figure 4
6. USING LOCATING TOOLS
Solder Assembly Kit 1055466–1 contains four locating
tools. Refer to the connector specific instruction sheet
for selection of proper locator tool and assembly
instructions.
Type A, as well as Type B locating tools are available.
6.1. Using Type A Locating Tools
The solder assembly kit contains two Type A locator
tools. These tools are designed to be used with the
fixture subassembly. To insure proper connector
assembly, follow the instructions listed below.
DANGER
1. Place connector housing on end of cable
sub–assembly. The subassembly refers to cable
with center contact.
2. Place loose connector assembly in fixture base.
3. Nest the center contact in locator tool.
4. Tighten the thumbscrew to secure the cable.
5. Tighten the locator tool to seat the cable firmly.
6. Slide connector housing over locator tool.
7. Maintain position of housing firmly against
locator tool.
To avoid personal injury, be sure to observe all
local safety practices (including the use of
gloves). The solder gage, center contact holder,
and the contact may be hot after soldering.
Clamp
Inserts
Positioning
Tool
408–8780
Spring
3 of 4