DEMOMPR083 Freescale Semiconductor, DEMOMPR083 Datasheet - Page 22

• Manufacturer Part Number: DEMOMPR083
• Description: BOARD DEMO FOR MPR083 CTLR
• Manufacturer: Freescale Semiconductor

Specifications of DEMOMPR083

• Sensor Type: Touch, Capacitive
• Sensing Range: 8 Buttons/Keys
• Interface: I²C
• Voltage - Supply: 1.8 V ~ 3.6 V
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: MPR083
• Operating Voltage: 1.8 V to 3.6 V
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Operating Current: 41 uA
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Sensitivity: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: MPR083

MPR083
22
9
9.1
The MPR083 can operate in a variety of environments with a variety of different electrode patterns. Because of this it is necessary
to adjust the relative sensitivity of the sensor controller. Usually this requires fine tuning in any final application.
There are many factors that must be taken into account, but much of the time this value is relative to the capacitance changes
generated by a touch. Since capacitance is directly proportional to the dielectric constant of the material and the area of the pad,
while inversely proportional to the distance between pads these are the primary factors.
As the relative capacitance rises the sensitivity setting of the MPR083 should be adjusted accordingly. Thus a very high sensitivity
value represents a large A and a small d.
9.2
The sensitivity of the MPR083 is adjusted by varying the Sensitivity Threshold Register.
9.2.1
The sensitivity register allows the sensitivity of the MPR083 to be adjusted for any situation. The I
Sensitivity Threshold Register is 0x04.
Table 16. Sensitivity Threshold Register Field Descriptions
Sensitivity
Introduction
Adjusting the Sensitivity
Sensitivity Threshold Register
Reset:
Field
7:0
ST
W
R
7
0
= Unimplemented
Sensitivity Threshold – The Sensitivity Threshold selects or reports the sensitivity
setting of the Sensor Controller. The resulting value must be in the range 1 to 64
units. If the value is outside of this range the ST will be set to 00111111.
00000000 Encoding 0 – Sets the sensitivity to level 1
~
00111111 Encoding 63 – Sets the sensitivity to level 64
6
0
Figure 26. Sensitivity Threshold Register
C
5
0
=
ke
----------- -
d
0
A
4
0
SL
Description
0
3
2
0
2
1
0
C slave address of the
Freescale Semiconductor
0
0
Equation 8
Sensors