M25P40-VMP6TG NUMONYX, M25P40-VMP6TG Datasheet - Page 13

• Manufacturer Part Number: M25P40-VMP6TG
• Description: IC FLASH 4MBIT 50MHZ 8VFQFPN
• Manufacturer: NUMONYX
• Series: Forté™r

Specifications of M25P40-VMP6TG

• Format - Memory: FLASH
• Memory Type: FLASH
• Memory Size: 4M (512K x 8)
• Speed: 50MHz
• Interface: SPI, 3-Wire Serial
• Voltage - Supply: 2.3 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-VFQFN, 8-VFQFPN
• Memory Configuration: 512K X 8
• Ic Interface Type: Serial, SPI
• Clock Frequency: 50MHz
• Supply Voltage Range: 2.3V To 3.6V
• Memory Case Style: VDFPN
• No. Of Pins: 8
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

4.5
4.6
All other instructions are ignored while the device is in the Deep Power-down mode. This
can be used as an extra software protection mechanism, when the device is not in active
use, to protect the device from inadvertent Write, Program or Erase instructions.
Status Register
The Status Register contains a number of status and control bits that can be read or set (as
appropriate) by specific instructions. For a detailed description of the Status Register bits,
see
Protection modes
The environments where non-volatile memory devices are used can be very noisy. No SPI
device can operate correctly in the presence of excessive noise. To help combat this, the
M25P40 features the following data protection mechanisms:
In addition to the low power consumption feature, the Deep Power-down mode offers extra
software protection from inadvertent Write, Program, and Erase instructions, as all
instructions are ignored except the Release from Deep Power-down instruction.
Section 6.4: Read Status Register
Power On Reset and an internal timer (t
inadvertent changes while the power supply is outside the operating specification.
Program, Erase and Write Status Register instructions are checked that they consist of
a number of clock pulses that is a multiple of eight, before they are accepted for
execution.
All instructions that modify data must be preceded by a Write Enable (WREN)
instruction to set the Write Enable Latch (WEL) bit. This bit is returned to its reset state
after the following events:
–
–
–
–
–
–
Software Protected Mode (SPM): The Block Protect (BP2, BP1, BP0) bits allow part of
the memory to be configured as read-only.
Hardware Protected Mode (HPM): The Write Protect (W) signal allows the Block
Protect (BP2, BP1, BP0) bits and Status Register Write Disable (SRWD) bit to be
protected.
Power-up
Write Disable (WRDI) instruction completion
Write Status Register (WRSR) instruction completion
Page Program (PP) instruction completion
Sector Erase (SE) instruction completion
Bulk Erase (BE) instruction completion
(RDSR).
PUW
) can provide protection against
13/61