XRT91L32ES Exar, XRT91L32ES Datasheet - Page 23

• Manufacturer Part Number: XRT91L32ES
• Description: LIN Transceivers SONET SDH 8 bit TRANCEIVER
• Manufacturer: Exar

Specifications of XRT91L32ES

• Product Category: LIN Transceivers
• Rohs: yes

xr
REV. 1.0.3
The transmit section of the XRT91L32 accepts 8-bit parallel data and converts it to serial Differential LVPECL
data output intented to interface to an optical module. It consists of an 8-bit parallel Single-Ended LVTTL
interface, Parallel-to-Serial Converter, a clock multiplier unit (CMU), a Low Voltage Positive-referenced Emitter-
Coupled Logic (LVPECL) differential line driver, and Loop Timing modes. The LVPECL serial data output rate is
622.08 Mbps for STS-12/STM-4 applications and 155.52 Mbps for STS-3/STM-1 applications. The high
frequency serial clock is synthesized by a PLL, which uses a low frequency clock as its input reference. In
order to synchronize the data transfer process, the synthesized 622.08 MHz for STS-12/STM-4 or 155.52 MHz
STS-3/STM-1 serial clock output is divided by eight and the 77.76 MHz (STS-12/STM-4) or 19.44 MHz (STS-3/
STM-1) clock respectively is presented to the framer/mapper device to be used as its timing source.
The parallel data from an framer/mapper device is presented to the XRT91L32 through an 8-bit Single-Ended
LVTTL parallel bus interface TXDI[7:0]. To directly interface to the XRT91L32, the SONET Framer/ASIC must
be synchronized to the same timing source TXPCLK_IO in presenting data on the parallel bus interface. The
data must meet setup and hold times with respect to TXPCLK_IO. This clock output source is used to
synchronize the SONET Framer/ASIC to the XRT91L32. The framer/mapper device should use TXPCLK_IO
as its timing source so that parallel data is phase aligned with the serial transmit data. The data is latched into
a parallel input register on the rising edge of TXPCLK_IO. TXPCLK_IO is derived from a divide-by-8 of the high
speed synthesized clock resulting in a 77.76/ 19.44 MHz Single-Ended LVTTL clock output source to be used
by the framer/mapper device for parallel bus synchronization. A simplified block diagram of the transmit
parallel bus clock output system interface is shown in Figure 11.
F
3.0 TRANSMIT SECTION
3.1
IGURE
11. T
Transmit Parallel Input Interface
RANSMIT
P
ARALLEL
SONET Framer/ASIC
I
NPUT
I
NTERFACE
STS-12/STM-4 OR STS-3/STM-1 SONET/SDH TRANSCEIVER
TXDI[7:0]
B
LOCK
TXPCLK_IO
8
21
TTLREFCLK
STS-12/STM-4
STS-3/STM-1
Transceiver
XRT91L32
REFCLKP
or
REFCLKN
CMUREFSEL
XRT91L32