PCA9521D,118 NXP Semiconductors, PCA9521D,118 Datasheet - Page 15

• Manufacturer Part Number: PCA9521D,118
• Description: Interface - Signal Buffers, Repeaters
• Manufacturer: NXP Semiconductors
• Series: PCA9521r

Specifications of PCA9521D,118

• Rohs: yes
• Operating Supply Voltage: 2.7 V to 5.5 V
• Operating Temperature Range: - 40 C to + 85 C
• Mounting Style: SMD/SMT
• Package / Case: SOP-8
• Input Capacitance: 10 pF
• Maximum Clock Frequency: 1 MHz
• Maximum Operating Frequency: 1000 kHz
• Operating Current: 6 mA
• Power Dissipation: 300 mW
• Product Type: Buffers
• Propagation Delay Time: 45 ns
• Tx/rx Type: I2C, PMBus, SMBus

NXP Semiconductors
12. Handling information
13. Soldering of SMD packages
PCA9521
Product data sheet
CAUTION
13.1 Introduction to soldering
13.2 Wave and reflow soldering
This text provides a very brief insight into a complex technology. A more in-depth account
of soldering ICs can be found in Application Note AN10365 “Surface mount reflow
soldering description”.
Soldering is one of the most common methods through which packages are attached to
Printed Circuit Boards (PCBs), to form electrical circuits. The soldered joint provides both
the mechanical and the electrical connection. There is no single soldering method that is
ideal for all IC packages. Wave soldering is often preferred when through-hole and
Surface Mount Devices (SMDs) are mixed on one printed wiring board; however, it is not
suitable for fine pitch SMDs. Reflow soldering is ideal for the small pitches and high
densities that come with increased miniaturization.
Wave soldering is a joining technology in which the joints are made by solder coming from
a standing wave of liquid solder. The wave soldering process is suitable for the following:
Not all SMDs can be wave soldered. Packages with solder balls, and some leadless
packages which have solder lands underneath the body, cannot be wave soldered. Also,
leaded SMDs with leads having a pitch smaller than ~0.6 mm cannot be wave soldered,
due to an increased probability of bridging.
The reflow soldering process involves applying solder paste to a board, followed by
component placement and exposure to a temperature profile. Leaded packages,
packages with solder balls, and leadless packages are all reflow solderable.
Key characteristics in both wave and reflow soldering are:
•
•
•
•
•
•
•
•
Through-hole components
Leaded or leadless SMDs, which are glued to the surface of the printed circuit board
Board specifications, including the board finish, solder masks and vias
Package footprints, including solder thieves and orientation
The moisture sensitivity level of the packages
Package placement
Inspection and repair
Lead-free soldering versus SnPb soldering
This device is sensitive to ElectroStatic Discharge (ESD). Observe precautions for handling
electrostatic sensitive devices.
Such precautions are described in the ANSI/ESD S20.20, IEC/ST 61340-5, JESD625-A or
equivalent standards.
All information provided in this document is subject to legal disclaimers.
Rev. 2 — 19 March 2013
Fast dual bidirectional bus buffer
PCA9521
© NXP B.V. 2013. All rights reserved.
15 of 23