PCM-5862E ETC [List of Unclassifed Manufacturers], PCM-5862E Datasheet - Page 69

• Manufacturer Part Number: PCM-5862E
• Description: All in one multi-media Pentium processor-based single board computer
• Manufacturer: ETC [List of Unclassifed Manufacturers]

OS/2 Drivers Setup Procedure
Preliminary Steps
The following steps must be performed before you install the
65550/554 display driver:
1. OS/2 DOS Support must be installed.
2. If you previously installed SVGA support, you must reset the
To restore VGA mode, use Selective Install and select VGA for
Primary Display. For more information on this procedure, see the
section on Changing Display Adapter Support in the OS/2 User’s
Guide.
Installing from Diskette
To install this driver, do the following steps:
1. Open an OS/2 full screen or windowed session.
2. Place the 65550 PCI Display Driver Diskette in drive A.
3. At the OS/2 command prompt, type the following commands to
When the Setup Program is completed, you will need to perform a
shutdown and then restart the system in order for changes to take
effect.
A log of the information output during the install can be found in
<root>:\OS2\INSTALL\DISPLAY.LOG
system to VGA mode. VGA is the default video mode enabled
when OS/2 is installed.
copy the files to the OS/2 drive:
Type:
A: <ENTER> to make this the default drive.
SETUP A: C: <ENTER>
where A: is the floppy disk drive and
C: is the hard disk partition containing \OS2
Chapter 5 PCI VGA Setup
61