PCM-5862E ETC [List of Unclassifed Manufacturers], PCM-5862E Datasheet - Page 26

no-image

PCM-5862E

Manufacturer Part Number
PCM-5862E
Description
All in one multi-media Pentium processor-based single board computer
Manufacturer
ETC [List of Unclassifed Manufacturers]
Datasheet
IDE hard drive connector (CN17)
18
2. Slip the memory module into the socket at a 45-degree angle.
3. Push the module toward the vertical posts at both ends of the
4. Repeat steps 2 and 3 for each module you install.
You can attach one or two Enhanced Integrated Device Electronics
hard disk drives to the PCM-5862E/5862EL’s internal controller.
The PCM-5862E/5862EL’s IDE controller uses a PCI local-bus
interface. This advanced IDE controller supports faster data
transfer, PID mode 3, mode 4.
Connecting the hard drive
Connecting drives is done in a daisy-chain fashion and requires one of
two cables (not included in this packing), depending on the drive size.
1.8" and 2.5" drives need a 1 x 44-pin to 2 x 44-pin flat-cable
connector. 3.5" drives use a 1 x 44-pin to 2 x 40-pin connector.
Wire number 1 on the cable is red or blue, and the other wires are gray.
1. Connect one end of the cable to CN17. Make sure that the red (or
2. Plug the other end of the cable to the Enhanced IDE hard drive,
Connect a second drive as described above.
Unlike floppy drives, IDE hard drives can connect to either end of the
cable. If you install two drives, you will need to set one as the master
and one as the slave by using jumpers on the drives. If you install
just one drive, set it as the master.
PCM-5862E/EL User's Manual
socket until the module is upright, and the retaining clips at both
ends of the module click into place. When positioned correctly,
the pins on top of the vertical posts should correspond to the
circular holes on the ends of the module.
blue) wire corresponds to pin 1 on the connector, which is labeled
on the board (on the right side).
with pin 1 on the cable corresponding to pin 1 on the hard drive.
(See your hard drive’s documentation for the location of the
connector.)

Related parts for PCM-5862E