PCM-5862E ETC [List of Unclassifed Manufacturers], PCM-5862E Datasheet - Page 50

• Manufacturer Part Number: PCM-5862E
• Description: All in one multi-media Pentium processor-based single board computer
• Manufacturer: ETC [List of Unclassifed Manufacturers]

System test and initialization
These routines test and initialize board hardware. If the routines
encounter an error during the tests, you will either hear a few short
beeps or see an error message on the screen. There are two kinds of
errors: fatal and non-fatal. The system can usually continue the
boot up sequence with non-fatal errors. Non-fatal error messages
usually appear on the screen along with the following instructions:
press <F1> to RESUME
Write down the message and press the F1 key to continue the
bootup sequence.
System configuration verification
These routines check the current system configuration against the
values stored in the board’s CMOS memory. If they don’t match,
the program outputs an error message. You will then need to run
the BIOS setup program to set the configuration information in
memory.
There are three situations in which you will need to change the
CMOS settings:
1. You are starting your system for the first time
2. You have changed the hardware attached to your system
3. The CMOS memory has lost power and the configuration
information has been erased.
The PCM-5862E/5862EL’s CMOS memory has an integral lithium
battery backup. The battery backup should last ten years in normal
service, but when it finally runs down, you will need to replace the
complete unit.
42
PCM-5862E/EL User's Manual