HIP6502BEVAL1 INTERSIL [Intersil Corporation], HIP6502BEVAL1 Datasheet - Page 12

• Manufacturer Part Number: HIP6502BEVAL1
• Description: Multiple Linear Power Controller with ACPI Control Interface
• Manufacturer: INTERSIL [Intersil Corporation]

specifications, certain imbalances between the ATX’s
outputs and the HIP6502B’s regulation levels could have as
a result a brisk transfer of energy from the input capacitors to
the supplied outputs. At the transition between active and
sleep states, this phenomena could result in the 5VSB
voltage dropping below the POR level (typically 4.1V) and
temporarily disabling the HIP6502B. The solution to a
potential problem such as this is using larger input
capacitors with a lower total combined ESR.
Transistor Selection/Considerations
The HIP6502B usually requires one P-Channel (or bipolar
PNP), three N-Channel MOSFETs and two bipolar NPN
transistors.
One important criteria for selection of transistors for all the
linear regulators/switching elements is package selection for
efficient removal of heat. The power dissipated in a linear
regulator/switching element is:
Select a package and heatsink that maintains the junction
temperature below the rating with the maximum expected
ambient temperature.
Q1
The active element on the 2.5V
bipolar NPN capable of conducting the maximum active
memory current and exhibit a current gain (h
40 at this current and 0.7V V
Q2
The NPN transistor used as sleep state pass element (Q2)
on the 3.3V
of 100 at 1.5V V
operating temperature range.
P
LINEAR
=
DUAL
I
O
CE
V
output has to have a minimum current gain
IN
and 500mA I
–
V
OUT
CE
12
MEM
.
CE
throughout the in-circuit
output has to be a
fe
) of minimum
HIP6502B
Q3, Q4, Q6
The three N-Channel MOSFETs are used to switch the 3.3V
and 5V inputs provided by the ATX supply into the 3.3V
3.3V
S1) state. The main criteria for the selection of these
transistors is output voltage budgeting. The maximum
r
expressed with the following equation:
V
V
I
The gate bias available for these MOSFETs is of the order of
8V.
Q5
If a P-Channel MOSFET is used to switch the 5VSB output
of the ATX supply into the 5V
states (as dictated by EN5VDL status), then the selection
criteria of this device is proper voltage budgeting. The
maximum r
4.5V of V
If a PNP device is chosen to perform this function, it has to
have a low saturation voltage while providing the maximum
sleep current and have a current gain sufficiently high to be
saturated using the minimum drive current (typically 20mA).
r
OUTmax
DS(ON)
DS ON max
INmin
OUTmin
DUAL
- minimum input voltage
allowed at highest junction temperature can be
GS
- maximum output current
- minimum output voltage allowed
/3.3V
DS(ON)
, so a logic level MOSFET needs to be selected.
=
V
-------------------------------------------------- -
SB
INmin
, and 5V
, however, has to be achieved with only
I
OUTmax
–
V
OUTmin
DUAL
DUAL
outputs, while in active (S0,
, where
output during S3 and S5
MEM
,