hb28j128mm3 Renesas Electronics Corporation., hb28j128mm3 Datasheet - Page 28

• Manufacturer Part Number: hb28j128mm3
• Description: Multimediacard 32 Mbyte/64 Mbyte/128 Mbyte/256 Mbyte/512 Mbyte
• Manufacturer: Renesas Electronics Corporation.

HB28K032/L064/J128/J256/J512MM3, HB28K032/L064/J128/J256RM3
Basic Commands (class 0) and Read Stream Command (class 1)
CMD
index
CMD0
CMD1
CMD2
CMD3
CMD4
CMD7
CMD9
CMD10 ac
CMD11 adtc
CMD12 ac
CMD13 ac
CMD15 ac
Notes: 1. CID register consists of 128 bits (starting with MSB, it is preceded by an additional start bit, ends
Rev.0.02, Sep.15.2004, page 28 of 89
2. CSD register consists of 128 bits (starting with MSB, it is preceded by an additional start bit,
3. This command is indicating the busy status of the MultiMediaCard via the data channel.
Type Argument
bc
bcr
bcr
ac
bc
ac
ac
with an end bit)
ends with an end bit)
[31:0] stuff bits
[31:0] OCR
without busy
[31:0] stuff bits
[31:16] RCA
[15:0] stuff bits
[31:16] DSR
[15:0] stuff bits
[31:16] RCA
[15:0] stuff bits
[31:16] RCA
[15:0] stuff bits
[31:16] RCA
[15:0] stuff bits
[31:0] data
address
[31:0] stuff bits
[31:16] RCA
[15:0] stuff bits
[31:16] RCA
[15:0] stuff bits
Resp
R3
R2
R1
R1b (only
the
selected
card)
R2
R2
R1
R1b*
R1
3
Abbreviation
GO_IDLE_STATE
SEND_OP_COND
ALL_SEND_CID
SET_RELATIVE_A
DDR
SET_DSR
SELECT/
DESELECT_CARD
SEND_CSD
SEND_CID
READ_DAT_UNTIL
_STOP
STOP_TRANSMISS
ION
SEND_STATUS
GO_INACTIVE_ST
ATE
Command description
Resets all cards to Idle State
Checks for cards not supporting the
full range of 2.0 V to 3.6 V. After
receiving CMD1 the card sends an R3
response (refer to Chapter
“Responses”).
Asks all cards in ready state to send
their CID*
Assigns relative address to the card in
identification state.
Programs the DSR of all cards in
stand-by state.
Command toggles a card between the
standby and transfer states or between
the programming and disconnect state.
In both cases the card is selected by
its own relative address while
deselecting the prior selected card.
Address 0 deselects all.
Asks the addressed card to send its
card-specific data (CSD)*
line.
Asks the addressed card to send its
card identification (CID) on CMD-line.
Reads data stream from the card,
starting at the given address, until a
STOP_TRANSMISSION follows.
Forces the card to stop transmission
Asks the addressed card to send its
status register.
Sets the card to inactive state in order
to protect the card stack against
communications breakdowns.
1
numbers on CMD-line
2
on CMD-