mpc5645s Freescale Semiconductor, Inc, mpc5645s Datasheet - Page 35

no-image

mpc5645s

Manufacturer Part Number
mpc5645s
Description
Mpc5645s Microcontroller Data Sheet
Manufacturer
Freescale Semiconductor, Inc
Datasheet
VIU input data selection is done based on select bit (bit 0) of Miscellaneous control register (0xC3FE0340).
2.4.7
The SGM shares pins between the PWM output signals and the I2S bus signals as shown in the “Port pin summary” table. When
the PWM function is enabled in the SGM (SGMCTL[PWME]) the PWM (PWMO, PWMOA) signals are available. When the
PWM function is disabled the I2S bus signals (I2S_DO, I2S_SCK) are available.
2.4.8
Ports PA[0:15], PG[0:7], PG[11] and PM[2] have the RSDS signalling option as a special function. The SIUL allocates pad
control registers to these functions (PCR[270:282]), but because these pads share a common pin with the normal GPIO pins
they do not operate in the same way as the normal GPIO ports. PG[11] in particular has a special configuration separate from
the other pads.
The special-function pads are output-only, and the associated PCR[OBE] bit is controlled by the TCON_CTRL1 register
(TCON_BYPASS and RSDS_MODE bits). However, the alternate function selection is taken from the associated normal GPIO
pad. This allows selection of the DCU3 function as the alternate function of the pad and then the TCON module to select if the
output style is TCON/RSDS or digital RGB format.
Therefore, when the TCON bypass is active (bypass disabled with or without RSDS active), it is important not to configure the
normal GPIO ports for output operation with a non-DCU3 alternate function on ports PA[0:15] and PG[0:7].
For PG[11], the PCR[282] OBE bit is fully controlled by the TCON module and will become an output whenever the DCU3
alternate option is selected. Therefore, only select the DCU3 function on this pin when ready to configure it as a clock for a TFT
panel.
Freescale Semiconductor
DE
PDI_PCLK
VSYNC
HSYNC
DATA[17:0]
VIU_PCLK
VIU pix data: VIU[9:0]
Select bit 1’b0: PDI[7:0],HSYNC,VSYNC
Select bit 1’b1: PDI[17:8]
SGM muxing
RSDS special function muxing
Figure 5. VIU2, DCU3, and DCULite pin sharing
VIU[9:0]
MPC5645S Microcontroller Data Sheet, Rev. 6
VIU2
RGB565
RGB888
8-bit mono
YUV422
PDI
Direct feed of PDI interface
to DCU3 or DCULite
DCU3
XBAR
Pinout and signal descriptions
PDI
DCULite
35

Related parts for mpc5645s