W39V040FAP Winbond Electronics, W39V040FAP Datasheet - Page 39

• Manufacturer Part Number: W39V040FAP
• Manufacturer: Winbond Electronics

Specifications of W39V040FAP

• Density: 4Mb
• Access Time (max): 150ns
• Interface Type: Parallel/Serial
• Boot Type: Top
• Address Bus: 4/11Bit
• Operating Supply Voltage (typ): 3/3.3V
• Operating Temp Range: 0C to 70C
• Package Type: PLCC
• Program/erase Volt (typ): 3.3V
• Sync/async: Async/Sync
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 3V
• Operating Supply Voltage (max): 3.6V
• Word Size: 8b
• Number Of Words: 512K
• Supply Current: 20mA
• Mounting: Surface Mount
• Pin Count: 32
• Lead Free Status / Rohs Status: Not Compliant

15. VERSION HISTORY
Winbond products are not designed, intended, authorized or warranted for use as components in systems or
equipment intended for surgical implantation, atomic energy control instruments, airplane or spaceship instruments,
transportation instruments, traffic signal instruments, combustion control instruments, or for other applications
intended to support or sustain life. Further more, Winbond products are not intended for applications wherein failure
of Winbond products could result or lead to a situation wherein personal injury, death or severe property or
environmental damage could occur.
Winbond customers using or selling these products for use in such applications do so at their own risk and agree to
fully indemnify Winbond for any damages resulting from such improper use or sales.
VERSION
A1
A2
A3
A4
A5
A6
Aug. 20 , 2004
June 19, 2002
Dec. 16, 2002
Nov. 18, 2003
Nov. 25, 2004
April 14, 2005
DATE
1, 16, 33
PAGE
1 , 33
23
15
16
33
39
3
-
Important Notice
Initial Issued
Delete AC Test Load and Waveform.
Add a note below Read/Write Cycle Timing Parameter
Modify PGM mode power supply current (Icc) parameter
from 20mA(typ.) to 10mA(typ.) and 30mA(max.) to
20mA(max.)
Modify FWH mode power supply current (Icc) parameter
from 40mA(typ.) to 12.5mA(typ.) and 60mA(max.) to
20mA(max.)
Modify Standby current (Isb1) parameter from 20μA(typ.)
to 5μA (typ.) and 100μA (max.) to 25μA (max.)
Modify the description of Interface Mode Selection: When
IC pin is set to V
mode. (V
Add Lead free part
Add lead free word in package table
Add important notice
- 39 -
DD
is changed from High State)
DD,
the device will be in the Programmer
Publication Release Date: April 14, 2005
DESCRIPTION
W39V040FA
Revision A6