LQ230M1LW11 Sharp Electronics, LQ230M1LW11 Datasheet - Page 28

• Manufacturer Part Number: LQ230M1LW11
• Manufacturer: Sharp Electronics

Specifications of LQ230M1LW11

• Lead Free Status / Rohs Status: Compliant

13.Precautions in regards of designing module mounting
14. Packing form
a) Piling number of cartons: （ ２ ）
b) Packing quantity in one carton : 2 module
c) Carton size : 620(W)×447（ H） ×276(D) mm
d) Total mass of one carton filled with full modules : （ 16.0） Kg（ TYP）
e) Packing form figures are shown in Fig.3
(f) This module generates many heat. It is necessary to apply a cooling method in product side.(cooling
(g) If a minute particle enters in the module and adheres to an optical material, it may cause display
(h) Before product design, please ask us about thermal design.
(i) When any question or issue occurs, it shall be solved by mutual discussion.
(e) When Mounting LCD module with M3 screws (x6), tighten the screws with torque below
(a) Excessive force should not be applied to the screen or the rear side of the LCD module.
(b) Avoid twisting and bending the LCD module.
(c) Avoid extending the power cable between the LCD module and LED drive circuit.
(d) Keep the backlight cable apart from the metal enclosure of the LCD module.
fun etc.)
non-uniformity issue, etc. Therefore, fine-pitch filters have to be installed to cooling and inhalation
hole if you intend to install a fan.
Excessive pressure on the screen caused by the installation of the LCD module may deteriorate
display quality and reliability.
Brightness uniformity and the reliability of LED may decrease if the pressure is applied to the
backlight module.
Excessive twist and bend may damage display quality and reliability.
This may cause the backlight not to light.
When frequency current for backlight driving leak to the metal enclosure, the desired brightness may
not be assured.
( T.B.D ).