CS5566-ISZ Cirrus Logic Inc, CS5566-ISZ Datasheet - Page 13

• Manufacturer Part Number: CS5566-ISZ
• Description: IC ADC 24BIT 1CH 5KSPS 24SSOP
• Manufacturer: Cirrus Logic Inc

Specifications of CS5566-ISZ

• Package / Case: 24-SSOP
• Number Of Bits: 24
• Data Interface: Serial
• Number Of Converters: 1
• Voltage Supply Source: Dual ±
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Architecture: Delta-Sigma
• Conversion Rate: 50 KSPs
• Input Type: Voltage
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 598-1557 - BOARD EVAL FOR CS5566 ADC
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 598-1269-5

3/25/08
CS5566
2. OVERVIEW
The CS5566 is a 24-bit analog-to-digital converter capable of 5 kSps conversion rate. The device is ca-
pable of switching multiple input channels at a high rate with no loss in throughput. The ADC uses a
low-latency digital filter architecture. The filter is designed for fast settling and settles to full accuracy in
one conversion.
The converter is a serial output device. The serial port can be configured to function as either a master or
a slave.
The converter can operate from an analog supply of 5V or from ±2.5V. The digital interface supports stan-
dard logic operating from 1.8, 2.5, or 3.3 V.
The CS5566 converts at 5 kSps when operating from a 8 MHz input clock.
3. THEORY OF OPERATION
The CS5566 converter provides high-performance measurement of DC or AC signals. The converter can
be used to perform single conversions or continuous conversions upon command. Each conversion is in-
dependent of previous conversions and can settle to full specified accuracy, even with a full-scale input
voltage step. This is due to the converter architecture which uses a combination of a high-speed delta-sig-
ma modulator and a low-latency filter architecture.
Once power is established to the converter, a reset must be performed. A reset initializes the internal con-
verter logic.
If CONV is held low then the converter will convert continuously with RDY falling every 1600 MCLKs. This
is equivalent to 5 kSps if MCLK = 8.0 MHz. If CONV is tied to RDY, a conversion will occur every
1602 MCLKs. If CONV is operated asynchronously to MCLK, it may take up to 1604 MCLKs from CONV
falling to RDY falling.
Multiple converters can operate synchronously if they are driven by the same MCLK source and CONV
to each converter falls on the same MCLK falling edge. Alternately, CONV can be held low and all devices
are reset with RST rising on the same falling edge of MCLK.
The output coding of the conversion word is a function of the BP/UP pin.
The active-low SLEEP signal causes the device to enter a low-power state. When exiting sleep, the con-
verter will take 3083 MCLK cycles before conversions can be performed. RST should remain inactive
(high) when SLEEP is asserted (low).
DS806PP1
13