FDC37B782-NS Standard Microsystems (SMSC), FDC37B782-NS Datasheet - Page 146

• Manufacturer Part Number: FDC37B782-NS
• Manufacturer: Standard Microsystems (SMSC)

Specifications of FDC37B782-NS

• Lead Free Status / RoHS Status: Supplier Unconfirmed

This chip employs soft power management to
allow the chip to enter low power mode and to
provide a variety of wakeup events to power up
the chip.
control over powerdown and wakeup events. In
low power mode, the chip runs off of the trickle
voltage, VTR. In this mode, the chip is ready to
power up from either the power button or from one
of a number of wakeup events including pressing a
key, touching the mouse or receiving data from
one of the UARTs. The alarm can also be set to
power up the system at a predetermined time to
perform one or more tasks.
The implementation of Soft Power Management is
illustrated in Figure 11. A high to low transition on
the Button input or on any of the enabled wakeup
events (SPx) causes the nPowerOn output to go
active low which turns on the main power supply.
Even if the power supply is completely lost (i.e.,
VTR is not present) the power supply can still be
turned on upon the return of VTR.
accomplised by an alarm event that has already
passed (if the alarm remember bit is enabled) or
by a VTR power on reset (if the VTR POR bit is
enabled). These bits are described in the RTC
This technique allows for software
SOFT POWER MANAGEMENT
This is
148
section.
always stay off when the AC power returns. (See
VTR_POR_OFF in the RTC section.)
The Button input can be used to turn off the power
supply after a debounce delay. The power supply
can also be turned off under software control (via a
write to register WDT_CTRL with bit 7 set).
Configuration
CR_B1 select the wakes-up events (SPx). The
Configuration
CR_B3 indict the wake-up event status.
possible wake-events are:
•
•
•
•
•
•
•
•
•
•
UART1 and UART 2 Ring Indicator Pin
Keyboard and Mouse clock Pin
Group Interrupt 1, Group Interrupt 2
IRRX2 input pin
RTC Alarm
UART 1 and UART 2 Receive Data Pin
nRING pin
Consumer IR (CIR)
Power Button input pin
VTR_POR
The chip can also be programmed to
registers
registers
L8-CR_B0
L8-CR_B2
and
and
The
L8-
L8-