5962-87650033A E2V, 5962-87650033A Datasheet - Page 11

• Manufacturer Part Number: 5962-87650033A
• Manufacturer: E2V

Specifications of 5962-87650033A

• Lead Free Status / RoHS Status: Supplier Unconfirmed

DSCC FORM 2234
APR 97
(original equipment), design applications, and logistics purposes.
contractor-prepared specification or drawing.
the individual documents. This coordination will be accomplished using DD Form 1692, Engineering Change Proposal.
requires configuration control and the applicable SMD. DSCC will maintain a record of users and this list will be used for
coordination and distribution of changes to the drawings. Users of drawings covering microelectronics devices (FSC 5962)
should contact DSCC-VA, telephone [phone].
[phone].
HDBK-103 have agreed to this drawing and a certificate of compliance (see 3.7 herein) has been submitted to and accepted
by DSCC-VA.
5. PACKAGING
5.1 Packaging requirements. The requirements for packaging shall be in accordance with MIL-PRF-38535, appendix A.
6. NOTES
6.1 Intended use. Microcircuits conforming to this drawing are intended for use for Government microcircuit applications
6.2 Replaceability. Microcircuits covered by this drawing will replace the same generic device covered by a
6.3 Configuration control of SMD's. All proposed changes to existing SMD's will be coordinated with the users of record for
6.4 Record of users. Military and industrial users shall inform Defense Supply Center Columbus when a system application
6.5 Comments. Comments on this drawing should be directed to DSCC-VA, Columbus, Ohio 43216-5000, or telephone
6.6 Approved sources of supply. Approved sources of supply are listed in MIL-HDBK-103. The vendors listed in MIL-
DEFENSE SUPPLY CENTER COLUMBUS
MICROCIRCUIT DRAWING
COLUMBUS, OHIO 43216-5000
STANDARD
1/ * PDA applies to subgroup 1 and 7.
2/ ** See 4.3.1c.
3/ Any or all subgroup may be combined when using a high speed tester.
4/ Subgroup 7 and 8 shall consist of verifying the pattern specified.
5/ For all electrical tests, the device shall be programmed to the pattern specified.
Interim electrical parameters
Final electrical test parameters
Group A test requirements
Groups C and D end-point
(method 5004)
(method 5004)
(method 5005)
electrical parameters
(method 5005)
MIL-STD-883 test requirements
TABLE II. Electrical test requirements. 1/ 2/ 3/ 4/ 5/
SIZE
A
1, 2, 3, 4**, 7, 8A, 8B, 9, 10, 11
MIL-STD-883, method 5005,
(in accordance with
1*, 2, 3, 7*, 8A, 8B, 9
2, 3, 7, 8A, 8B
Subgroups
REVISION LEVEL
table I)
- - -
E
SHEET
5962-87650
11